Search results

  1. M

    Who makes a 14' fiberglass walk-thru to replace my 85 Mckee Craft???

    I'd like to replace my old 1985 McKee craft which has caught enough fish to sink it but I can't find anyone who makes something comparable. McKee still makes the hull but doesn't offer it in the walk-thru design anymore, who's stepped in to fill this market??
  2. M

    Venting I/O engine compartment necessary after towing?

    I have a new to me Aquasport 222 with 5.7L Volvo I/O. I've read lots about boats with I/O exploding when the boat is re-fueled and the engine started without first running the blower. What if the boat is re-fueled while on the trailer then the boat is towed to the launch. The vents on the engine...
  3. M

    Early 90's 225s stored for 3 years, before I start them I should.......

    Here's the deal, and old friend of a friend has a 25' Gravois welded deep vee that he bought but it was too much for him to handle, so it sat in his back yard, and sat, and sat, he'll take $5K for the whole rig, the hulls worth that, but it has twin 225 Evinrudes on it that have sat for at least...
  4. M

    Volvo/Cobra SX as good as Alpha 1?

    I'm considering purchase of a 22' aquasport with 5.7L volvo penta that has a Cobra SX dirve. I have no experience with this drive but did have a 5.7L mercruiser with Alpha1 that performed well. Which outdrive is better?
  5. M

    115 SPL Overheat alarm comes on after 5 minutes idling?

    On my 1998 115 SPL the overheat alarm goes off after about 5 minutes of idling while I'm still in the no-wake zone. The water pump is working properly and a good hard stream from the motor. I unplug the horn and wait another 5 minutes, plug it back in, and never hear from it again. Any ideas?
  6. M

    Adaptor for controls when upgrading?

    I am upgrading engines going from a 1990 Evinrude 100 to a 1998 Johnson 115 SPL and would like to continue to use my existing controls and ignition. The older motor used the big red plug at the motor but the new motor is set up differently. Is there an adaptor that I can use?
  7. M

    2001 Johnson 135???

    Anyone know anything good or bad about this engine? I have an opportunity to purchase one in almost new condition but I am not familiar with this model. Any input would be helpful. Thanks.
  8. M

    2001 Johnson 135???

    Anyone know anything good or bad about this engine? I have an opportunity to purchase one in almost new condition but I am not familiar with this model. Any input would be helpful. Thanks.
  9. M

    Can I switch ignition systems between carb and EFI?

    Can I put an ignition from a 1998 200 EFI V-6 on a 1993 135 carbed V-6?
  10. M

    What should compression be on 135 V-6?

    What should the compression be on 1993 mercury 2 litre 135 V-6? I'm getting 105-115 for each cylinder.
  11. M

    Tight shift shaft on 93 135 merc

    My 1993 Merc 135 shifting is very tight. I removed the shift cable at the engine and tried to move the shift shaft but it's very tight. Is there anything I can do without removing the power head and/or lower unit to loosen it up?
  12. M

    Oil Capacity for 4 stroke 60 yamaha

    Can anyone tell me what the oil capacity is for a 2002 yamaha 60 four stroke? Thanks!!
  13. M

    Sometimes my motors charge batteries, sometimes not?

    I have two 1993 135 Mercurys. When I bought the boat I immediately moved the batteries from the bilge area to under the center console. This added 10-12' of battery cables. The cable coming off the motors is 6 awg, I extended the cables using 2 awg. Sometimes my voltmeters indicate that the...
Top