Search results

  1. A

    Penta 4.3 GLA distributor cap wiring

    I recently got a used boat with a Volvo Penta 4.3 GLA carburetor and swapping out the rotor, cap, wire, and spark plugs. The labeling of the old wire doesn't match up with the picture from the service manual. It ran so once in a while it will have a pop (attached a picture of the old wire in...
  2. A

    Roadblock with Gearcase head/propeller shaft seal replacement.

    This is for a '64 Evinrude 18hp 18402D. The propeller shaft called for part number 313284, Sierra lower seal kit come with part number 311787 equivalent. There should not be a fitment issue with either of this part. One is ID .625, OD 1.125, Height 0.312 the other is ID .625, OD 1.128, Height...
  3. A

    '64 Evinrude 18 gear case seal question?

    Hi, I am a newbie to the boating world, recently I got a used 14' aluminum with a '64 Evinrude 18 hp. The motor ran and idle fine, start with a few pull when cold. However, when the rev up all the way it maxed out at 10 mph with one small person on board. After reading a lot about use motor and...
  4. A

    New to boating and towing, trailer axle?

    Hi Everyone, I let go of my kayak and boat a little tin can so my wife and 2 kids can join in. I am in the progress of replacing the tires (original tires on there is 4.8-12) and while I am at it mine as well redo the bearing. I pulled out the hub and found this, pictured. What are some of the...
Top