Search results

  1. F

    2003 SeaPro SV2300 CC-How do you get to the fuel anti-siphon fitting?

    I am trying to get a boat running that sat too long after my friend passed away. I've now replaced all of the pumps and filters in the Yamaha HPDI engine (UGH!), but have a fuel obstruction between the tank and the fuel filter/water separator. The only access hole is directly over the fuel...
  2. F

    Z150TXRB HPDI STILL a problem, now starving for fuel

    I have a 2003 engine that sat for about a year, probably with ethanol gas in it, after my friend passed away. From my previous post, I have: emptied as much of the tank as I could, sent the injectors off, replaced the fuel filter, replaced the VST pump and its filter, replaced the lift pumps...
  3. F

    2003 Yamaha 150 HPDI Fuel pressure dropping at higher RPM's

    Good morning! I friend of mine passed away last year, and I am trying to get his boat running again. It sat for about 8 months with gas station fuel, and then his daughter ran it. BAD! I have emptied the fuel tank, replaced the fuel filter, replaced the VST fuel pump (even though it may not...
  4. F

    Bravo III Aluminum housing- Repair Advice Needed

    I'm wondering if anyone has any experience trying to repair the pitting on a gear housing? <br /><br />I'm hoping to soon get my boat out of being held hostage for the last three months at the "Platinum" Mercruiser Marina, after having ANOTHER new engine installed. Now, I've found out that the...
  5. F

    Wanted: Bravo III Lower Unit

    Well, after the Marina having my boat for almost 3 months, I may soon be getting it back with ANOTHER engine (the last one they installed lasted for about 7 hours). But, the 1996 outdrive is VERY pitted/corroded, especially where the stainless steel props join the gear housing. Does anyone...
  6. F

    Where I can send a new 5.7L to be re-built?

    I have a engine that has less than 7 hours on it. I only had the boat for 20 minutes when the engine died. After SIX WEEKS, the "Premier" Marina finally got around to taking the engine out of the boat and says that the 4 starboard cylinders have water in them and the engine is froze up. They...
  7. F

    5.7L Mercruiser- Water in NEW engine- let Marina replace it again??

    I JUST got a 1996 Chaparral 24 with a newly rebuilt 5.7 mercruiser that was put in by a "Premier Service" marina and it had less than 10 hours on it when it died. The engine stopped suddenly while running at approximately 35 knots. We thought it must have run out of fuel at the time. After...
Top