Search results

  1. L

    Johnson 40 HP without a generator charging system

    I have a 1960 Johnson 40HP outboard. Model RDS-22. I am refinishing an old wooden Lyman boat and getting ready to put it in the water. I've never run the motor in the water, but have barrel tested the motor and it runs fine on short tests. It does not have a generator, but has electric start...
  2. L

    1960 40 hp- lot of oil during test run

    Completed rebuilding 1960 40 hp Johnson. Runs great, idles great. Temp/thermostat/water pump working well. Seemed to be running rich, with a lot of smoke, but adjusted low speed to what appears to be a good mix (less smoke). Also ran a compression test- both cylinders were 90 lbs. Also, my fuel...
  3. L

    1960 Johnson 40 HP, recommended fuel octane and fuel mixture

    Just finished refurbishing everything in the motor and lower unit and am ready to fire it up. To confirm, what is the recommended fuel mixture, I believe it is 24:1. Also what octane fuel should be used, high test, or regular? Thanks for the advice.
  4. L

    1960 Johnson 40 HP, pinion gear needle bearing, rollers fell out

    I am working on the lower unit of a 1960 Johnson 40 HP. After taking the prop shaft and all gears, etc., I pulled the pinion gear out per the service manual. When I moved the lower housing, the roller pins/needles all fell out. See included picture. It was surprising to me that the needles were...
  5. L

    Johnson 1960 40 HP - Armiture plate rotation

    I am a newbie, restoring a 1960 Johnson 40 hp outboard. Got no spark initially so I removed a very difficult flywheel and replaced the points, condensers, and coils. (one coil was burnt and cracked). I replaced the flywheel and the pull starter assembly to test for spark. I then pulled the rope...
Top