Search results

  1. M

    forward gear

    took my lower unit back off to check waterpump on my 1973 merc forgot to put the motor in forward gear.i know how to put L/U in forward but don't know how to put handle in forward having a time trying to put L/U back on. Can anyone tell me how to put back in forward Thanks Mike
  2. M

    waterpump

    i have a 1973 merc 7.5hp i just put another L/U on it with a new impeller i lined up the water tube with the guide tube and pushed the L/U into place and bolted it on. the gears all work fine but can't get water pump to pee i only let it run for about 10 seconds. how long should it take to pick...
  3. M

    7.5 merc

    i have a 1973 merc. 7.5hp serial #3623387,i need to find a lower unit. could someone tell me what year lower units will fit this motor? also will a 9.8 lower unit interchange with a 7.5? Thank you much for any help!!! mike
  4. M

    anti-seize

    when u put a new prop on is it best to use anti-seize lubricant on both the prop shaft and on hub,or use marine grease on shaft and anti seize on the hub?? I sure don,t want the prop to seize again!!! Thanks for your help Mike
  5. M

    prop guide

    Hi! Just got the Hub off the prop shaft on my 1973 merc.7.5 hp. Behind the hub and butting up to the Bearing Carrier is what mercury calls a propeller guide or collar. Was this suppose to come off with the prop and do I need to replace it? I need to replace the Bearing Carrier seal,what is best...
  6. M

    Lower Unit

    Lower Unit Hi! I have a 1973 merc 7.5hp It started getting water in the L/U and I noticed that the oil was seeping out at the rear of the prop.I finally got the prop off after soaking in penetrating oil overnight and using a jaw puller,but it left the metal hub on the shaft The hub is 2 1/2"...
  7. M

    Gasket

    ihave a 1973 7.5hp merc the vent screw is small likea 1/4" I can't find a gasket to fit anywhere! Rodbolt on a previous message seemed to know about this vent screw and said not to use an oring. What is best to make a gasket out of so it won't leak? Thanks so much for any help!!
  8. M

    prop stuck

    hi, need your help. i have a 1973 7.5 merc. i have been trying to get the prop off. i removed the prop nut and rear thrust hub without much trouble but can't get prop to come off. i soaked it with kroil penetrating oil overnight and it still won't budge.i've used a block of wood behind the prop...
  9. M

    carb.

    i have a 1974 7.5hp merc can i replace carb. with a 1974 carb. off a 9.8 merc. also if i do will i gain or lose any performance. Thank You for your help! Mike
  10. M

    hard start 74 7.5

    i have a 1974 mercury 7.5hp after it sits up for awhile say overnight it is hard to start and i have to use a small amount of starting fluid sprayed into the carb. afterwards it will crank right up and will have one pull cranks all day i have tried new plugs and checked for leaks.The motor runs...
  11. M

    sea foam

    i have a 1973 mercury 7.5hp and would like to know if it would hurt to mix seafoam with my regular gas tank while i'm fishing to help clean my motor? If so what ratio would i use to a 6 gal. tank and would it smoke alot with the additive added? Thank you for your help! mike12
  12. M

    spark plugs

    I have a 1973 Mercury 7.5hp outboard motor and would like to know which spark plug the factory calls for? Also I've heard that a gapped plug might be better in it and would like to know which one is best. Thank You for your help Mike
  13. M

    1973 Mercury 7.5hp no spark

    I have a 1973 Mercury 7.5hp outboard that i can't get it to spark on either cylinder. So far we have replaced the points and plastic insulators,put in new wiring new low and high speed charge coils and a new ignition module.The old module had a burn spot in it.Any suggestions would be...
Top