Search results

  1. N

    A prop question (enertia or other versus older props)

    Currently have a a 4.3l v6 omc fresh rebuild. I've experimented a bit. The prop it came with, old aluminum prop 14.5 x 21 wot at 4300rpms full tank two adults. I got a dirt cheap stainless steel prop same pitch and diameter (14.5 x 21) 3900 rpms same scenario with weight factors (once again this...
  2. N

    Installing new bellows

    Anything else I should know before I change the bellows in the omc cobra? I've read the manual and seems fairly straightforward: Coat the outer surface of the gimble bearing flange, watch for the grooves. Watch the positioning of the clamps mentioned in the manual. Anyone else have any tips...
  3. N

    A question on exhaust flaps 1989 Stern Drive 4.3 [ 432APRMED ]

    Just dropping the engine back into the boat after a rebuild, can't seem to find anywhere in the manual the position that the exhaust flaps should be in when OUT of the water sitting in the driveway. Mine are currently sitting in the full open position. Just wondering if this is correct or not or...
  4. N

    14' Starcraft Seafarer 72

    Hello I was hoping someone would be able to help me out with a boat I recently inherited from my father. I have been slowly in the process of restoring the boat and have issue with the boat performing bad at high speeds, you are going to have to bare with me I don't know all the technical terms...
Top