Search results

  1. C

    Sea Fox 226 Commander Helm Question

    I was looking at my first CC boat and I noticed that there was about a 1/4" gap where the floor meets the helm. It goes around the entire perimeter of the helm. The surrounding area seems to be filled in with caulk or some type of sealant. Is this gap normal on all CC boats? Thanks in advance...
  2. C

    Alpha Gen 2 Sterndrive Issue

    Pulled the boat for the season and heard some noise and confirmed I needed a new gimbal bearing. It's been 2 years since I replaced the water impeller so I purchased the parts (I've changed the impeller over the years so I know what I'm doing). No water in lube oil when drained. It was not...
  3. C

    5.0 MPI Water Pressure Sensor

    The water pressure reading on my Smartcraft fluctuates from 8 - 20 PSI at Idle up to 3000 RPM. I drove the boat yesterday and today for over an hour each time and the engine temp never exceeded 158 degrees. No overheating issues at all. When I shut the boat off and just turn the key to the...
  4. C

    Connect Garmin to Spare Set of Accessory Wires

    I would like to install a Garmin chartplotter using the spare accessory wires near the helm. If I do that, do the wires have power when the key is off or does the key need to be turned to the ACC position? Of course my battery switch will switched to bat 1 or 2. I want to avoid the...
Top