Search results

  1. M

    carpet glue

    when installing i/o carpet on a pontoon what wuld be the best glue to use water base or contacted
  2. M

    carpet

    hello what would be the best carpet to puy on a pontoon that is in a very hot climate that wont burn feet
  3. M

    28 foot pontoon prop

    I have a 28 foot kayot pontoon with a 4cly mercruiser I/o it weights 3080 without people or gear holds 32 gal of gas what would be a good prop to start with ? I have no prop right now so couldn't, test drive it
  4. M

    pontoon prop

    what would be a good starting point for a prop on a 28 foot pontoon with two toons and a 12o mercruiser inboard 2brl carb just got it running but have know prop any help would be appreciated
  5. M

    volvo penta 5.0 alternator

    on a volvo penta what should the voltage be coming out of l2 and if there is none what would cause to stop working
  6. M

    mercruiser on a pontoon with noise

    I have a 24 foot pontoon with a 120 4 cly mercruiser out drive that is bad will a out drive off a 165 6 cly work
  7. M

    prop size

    I have 28 foot 1980 kayot pontoon with a 120 mercruiser inboard engine it has a 3.0 mercruiser out drive what would be good starting point for a prop it does not have a prop right now .it came with a omc stringer out drive but we changed that over to merc,
  8. M

    mercruiser trim pump

    have a old type 74436a9 trim pump off a 6cly merc does anyone have a wiring diagram it has a single sol,
  9. M

    omc change over

    just a question I have a 1980 28 foot pontoon with a omc 120 4 cly stringer 400 out drive I am putting a mercruiser out of a boat with a 165 6 cly should I change the gears over to the 120 4 cly merc motor or leave them the 165 6 cly motor
  10. M

    omc 120 manifold

    will a omc 120 manifold work on a mercuiser set-up ? what i.m doing is putting a merc out drive off a 165 6cly merc boat on to my 120 omc motor in a pontoon
  11. M

    cooling problem

    this on a 4 cly omc stringer outdrive if I had the outdrive in a barrel of water with the cavitation under water would a get enough water to cool or should it be deeper in the water what I need to know is how much suction does the pump have at low rpm
  12. M

    Mercuiser swap out

    has anyone put a merc 4 cly outdrive in a pontoon that has a 4 cly omc out drive
  13. M

    omc out drive swap with merc out drive

    I have a in line 4 cly omc [chev] engine with a stringer out drive a friend of mine has a merc 6 cly with the out drive would the out drive fit on my engine the six would be to much for my pontoon [ weight wise] I know that it would be a lot of work but I have time
  14. M

    electric shift

    is the electric shift on a 120 1980 omc worth changing over to from manual shift
  15. M

    stringer coupler

    on a stringer coupler on a 120 4 cly chev is it rubber mounted or solid ? when we were out with the pontoon the engine would rev to 5000 and we would go no were it think it is the prop rubber but I don,t know if the coupler is mounted in rubber
  16. M

    prop size

    i have a 22 foot pontoon with a 1973 4 cly 65 hp 4 cly two stroke i need to konw if the prop is wright it has a 14 x 11p merc, prop it seems to run good but being my frist pontoon i don,t know i took the rpms up to 5200 but it seemed high so i backed it down to 4000 am i in the ball park with...
  17. M

    prop size help

    i have a 22 foot pontoon with two toons and a 1973 65 4 cly two stroke it has a 14 x 11p mercury prop i don,t know if it is the wright one or not it seems to go ok i took the rpms up to around 5200 and backed off seems a little high but i dont relay know this is my frist pontoon am i in the...
  18. M

    650 oil and smoke problem

    i have a 650 65 hp 2 stroke mercury outboard thats smoke a lot plugs look wet with oil i,m running it in a 55 gallon drum cut in half the drum has a lot of oil on top of the water after running about 15 min, i replaced the out put shaft seals still oil, the oil is real black motor runs smooth...
Top