Search results

  1. E

    Alarm

    Over heat buzzer goes off. Motor is not over heating but goes into limp mode. Mix my own oil and gas and motor is not hot to touch when buzzer goes off. Pulled entire buzzer off of ignition, bit still in limp mode. I think the ignition itself is bad. Could this be the problem....
  2. E

    Backfire

    2001 Yamaha 115 2 stroke, backfires once right before motor cranks. Happens most time if not been run for a week or so. Motor is not stored trimmed up or down but in the middle when it barley touches the trim sticks(not sure what the official term is). Is this normal? Do I need to adjust the...
  3. E

    Gauge issues

    Rpm gauge reads all over the place. Today it read 1000 while idling and I know it was not at 1000. I tapped the glass on the gauge and needle started jumping around until it started reading close to being right. Fuel gauge same thing and it hasn't worked for a while, I thought it was maybe the...
  4. E

    Kill switch/bad alarm

    Probably a dumb question but I'm gonna ask it anyway. Is there anyway possible that on a 2001 Yamaha 115 2 stroke if the kill switch is bad that it could cause the motor to go into safe mode when alarm sounds. Or could it be a faulty alarm itself. This is my first Yamaha and I found out the hard...
  5. E

    Water jacket gasket

    2001 Yamaha 115 2 stroke. Is it necessary to pull head covers to clean water jackets or can I just pull the water jacket covers off? I lossened up a couple of head bolts just to see if they were siezed. When the bolt was loosened there was a little salt on the threads. Same thing on water jacket...
  6. E

    Head temperature

    2001 Yamaha 115 2 stroke. Overheat alarm went off after about 2 hours of running. Turned motor off and back on, hit the throttle and motor went into safe mode with alarm going off.turned off again for about a minute and crunk it back up and no further issues. Has new thermostat and impeller...
  7. E

    Yamaha 115 2 stroke (2001)

    2001 yahmaha 115 stroke. Just had both carburetors redone and oil system taken out. Motor idled fine on hose yesterday, but now idles at around 1300 r.p.m. on hose..need a little guidance please. Any help is greatly appreciated
Top