Search results

  1. C

    MerCruiser 7.4L Bravo GM 454 V-8 1988-1991 Oil Filter & Adapter with two filters

    I have a Remote oil Filter Adapter with two filters. Does the system need two oil filters??? I shared this with Patrick in marineengines.com he could not find a cover either. This system is for MerCruiser 7.4L Bravo GM 454 V-8 1988-1991 Oil Filter & Adapter, 0B771113 - 0D603117. the large WIX...
  2. C

    72C Velvet Drive

    Looking for a 72C Velvet drive, 10-18-014 for a MerCruiser?
  3. C

    exhaust - Resolved

    resolved Hello , I just R&R my exhaust manifolds and noticed only one side had a exhaust flapper. 1986 OMC 4.3 stringer I have heard they have been discontinued to use on newer models. My 1972 threw the transom V-Drive Stevens flat bottom Did not have any flappers, never was a problem. So if...
  4. C

    Omc stringer vs cobra exhaust manifolds

    I just ran water to the hose inlet and stuck a rag in the 3.5 out let and water was pouring into my exhaust ports. This is on a 1985 4.3 omc stringer, Looking in EBAY are are some listed as OMC Cobra that have the same manifold castings as my stringer Port 984221 starboard 984222...
  5. C

    1985 OMC stringer 800 with a 4.3 possible cracked engine block

    I had a Topic on can you repace engine without pulling the out drive. Thank you for the replies. Now may not have to pull engine, I gave the cooling system a leak test of 23 lbs of air, the results was no leakage. The puzzling thing is the oil is milky. I changed the oil and filter twice...
  6. C

    Can a 4.3 engine be removed and replaced without pulling the omc outdrive?

    Hello, I have A 1985 OMC stringer 800 with a 4.3 cracked engine block, Can the engine be R&R removed and replaced with out removing the out drive? Seems like it would be impossible to slide the engine on to the gimbal bearing and shaft.
  7. C

    need help finding the location of 1986 stringer omc Trim Indicator Sending Unit

    Hello, I'm the newbe here. I just bought a 1986 Beachcraft, And found the Trim Indicator Sending Unit laying in the starboard side bilge area hot wire connected and ground disconnected. My manual does not show where it was mounted, it just shows a schematic diagram. I have looked every where for...
  8. C

    lubricant to use in 1985 OMC Stringer Intermediate Housing Tilt Clutch Assy

    Hello , I heard different lubes to use for 1985 OMC Stringer Intermediate Housing Tilt Clutch Assy. The manual says 30wt oil. I found 80/90 gear lube in mine, And some say pack the assy with marine grease. What say you? Thanks paul
Top