So for the past few years I have noticed that my boat has been sitting really low in the water, in the back. After doing some research and talking to a few people; it turns out the foam may be waterlogged. Well today I took out one of the seat mounts and was able to get to a small piece of the...
2001 75hp ELPTO
So I changed the impeller on my outboard and think I have an issue.
I put the motor in forward before removing the 5 nuts. Took the lower unit off and replaced the impeller and gaskets from a kit I bought.,
Had a hell of a time getting the unit back on. Put the shifter into...
So I just picked up a 1973 Johnson 20R73A 20 hp and had a question on how to start it. I'm pretty sure I know how but need a refresh. What do I set this dial to? And what is it's purpose?
I assume I pull the choke till the motor starts than close it. Right? Also, do I turn the throttle...
Hi can anyone help me find these things?
Looking for spark plug gap and plug recommendations.
Part number to replace the fuel filter.
And what the optimum RPMs to run at.
ser# 0t300451 - 75elpto - Mercury
Thank you
So the first kicker motor I had a couple years ago go all jacked up due to carbon build up. After speaking with the guys at a shop about it I was told it was due to the fact that the motor was always running at really low speeds/rpms which causes such build up.
So aside from running it at W.O.T...
I just picked up a Nissan 5hp long shaft 2 stroke and am looking for more info on it. Like what fuel to oil ratio I need to use for best and long lasting performance. Also the motor has a built in tank. I do see on the front there looks to be a hole where you would run a tube from an external...
I am the proud owner of a 2001 Monark King 160 SC, When the weather gets better I'd like to re-do some of the wiring. I wanted to know if anyone could help me and give me some info on how to remove the shelf panel on the drivers side of the boat? Here is a picture of the panel I need to remove...
I live in a apartment and because of this the only way to charge my trolling motor batteries is through my tow vehicle. Its no prob now seeing how I have a 12v system and can just charge from my truck. But I want to upgrade to a 24v motor. Will this work:
Thank you!
-Jay
Can anyone tell me what this is called and where I can buy a new one?
I know its part of a winch stand but I just need the bracket that holds the Bow Roller?
Its for a 2001 ez loader Model: YST Body: TU
Thank you
-Jay
The last 2 times up to mountains(8500ft) my kicker dies after troling for a long time. After 3 or 4 hours of straight trolling it will start slowing down than it starts choking than finally dies. If I let it sit for 20-30min and fire it back up its good to go again. Its getting fuel as the bulb...
Sometimes when I shift from forward to neutral the motor dies. Sometimes its hard to re-start after this happens. Anyone have any ideas?<br /><br />I got it in WY and was told the altitude there is so close to here(Denver) that I wouldnt need to have it tuned? Does this sound right?<br /><br...
Is there an ez way to try and fix my gas Gauge ? I know it could be a nuber of things but what should I try first?<br /><br />Also, Should the Gauge show how much gas if the motor isnt running? Its a 2001 75hp Merc<br /><br /><br />-Jay
Is there an ez way to try and fix my gas Gauge ? I know it could be a nuber of things but what should I try first?<br /><br />Also, Should the Gauge show how much gas if the motor isnt running? Its a 2001 75hp Merc<br /><br /><br />-Jay
It is my understanding that when I run my Big motor that that charges the battery while im running? I currently have A sonar, GPS, All lights and pumps hooked up to my cranking battery. How long should I be able to run all these things off that bettery before I should start it up to charge...
I just picked up a new boat and it has a bow mounted minn kota auto pilot. Does anyone know where I can get a manual for it? Im not sure how to use the autopilot opinion?<br /><br /><br />-Jay
I was trying to mount the tranducer for my humminbird Matrix 27 today and broke one of the mounting holes off of the xducer(See pic)<br /><br /> <br /><br />Does anyone have any suggestions on how to mount this thing now? <br /><br />Thanx<br /><br />-Jay
I just picked up my new boat this past weekend. A 2001 Monark King 160sc. It came with an older lowrance. I wanted to add my newer Humminbird Matrix 27. So after a few hours of unscrewing all sorts of stuff I got the Transducer wire and power wire ran. The power wire I hooked upto the cranking...
I have a 2001 Monark 160 King SC. Does anyone have any suggestions as to a good cover? I'd like to spend UNDER $180.00. The boat is stored outside and would have to hold up to some snow and rain.<br /><br />Thank you,<br /><br />-Jay
