Search results

  1. F

    2004 115hp 4cycle no fuel psi

    I have a 2004 115 HP saltwater outboard that wont start, has fire and runs whild spraying starter fluid in the intake. I checked the ohm's at the hi psi fuel pump and got 1.6 ohm's. The red wire has some voltage but the blue is open. I am thinking there is a fuel relay, safety sensor or needs to...
  2. F

    Yamaha 6 hP Japanese Impeller needed

    I have a japanese imported Yamaha 6 hp with a 35mm water pump housing bore, 12mm shaft size and a 18mm deck height. The Yamaha outboard dealer in Austin only shows a 13mm height for that year. The ID plate shows 84 07 I think that would mean July 1984. The other numbers are 6h6l 203020...
  3. F

    Mercury 9.9HP 2004--no fire after warmed up

    I have a Mercury 9.9, 4 cycle twin, single coil thawhen run for 5 minutes starts running on one cyl and then dies and has no fire. I disconected the black/yellow kill switch and button on the end of the tiller , no fire then. I ohm ed the stator wires 406 ohm's between them and open to body...
  4. F

    1981 115 rude rectifer replacment Gray wire position

    I am replacing a regulator on a 1981 Evinrude 115 HP outboard # J115TLCIM. I am trying to figure where the White or gray goes and what it does. I am replacing the rectifer after finding out batt voltage is the same with engine off or running at hi idleI. checked the rectifer and resistance...
  5. F

    110 hp evinrude- wont charge battery

    Hi, I have a Evinrude 110 hp v4 vro Model E110TLCPC / J1127369 that wont charge the battery. My guess is I should start by checking the a/c output of the stator. Then check the rectifer. My question is the color of the a/c stator wires and the voltage readings or the ohm values it should have...
  6. F

    90 HP Johnson, Ieaking Injection oil in carb

    I am a auto mechanic trying to repair an outboard motor and I sure do like I-boats.com.<br /><br />I am working on a 90 HP Johnson (or near that with a black cover v-4, 2-cycle.) that is leaking Injection oil into the fuel line and into the carbs carb. The motor was used once this year and is on...
  7. F

    Honda BF- 100 adjusting shift rod end

    I am tring to find out if there is an easier way to to adjust the shift rod after doing a water pump inpeller on the small Honda twins. I have been removing the rectifer and the shift spring stopper and then removing the shift shaft adjuster completely before pulling the lower unit to replace...
  8. F

    Dt-6 Suziki. Water pump question

    After installing a new water pump impeller in a DT-6 Suzuki I noticed week or no water flow at idle until reved up 1/4 of more with the water level above the water pump. When you fill the barrel water level above the shift shaft inspection hole it will pump week at idle and real good above that...
  9. F

    Evinrude 48Hp misses and dies

    I have a 48 hp rude E5RHLCIC that has had a rough life at a marina pushing a work barge. I will start when choked and idle well with fast idle bar completly up. When you lower it it idles ok until you put it in gear and dies. Some times it will run if I give it full throtle and then cuts out...
  10. F

    Evinrude 5HP Lower end removal

    I have a Evinrude 6905E older 5hp twin and am taking the lower unit off to install a water pump impeller and replace the lower end imput shaft seals that are leaking. It will not come out more than 5\8". Is there a pin in the powerhead that has to be removed first and how do you do that? <br...
  11. F

    yanmar 1 cyl diesel . too much black smoke

    I have checked the exhaust for blockage short of pulling off the elbo where water is added. This is on a hunter 28 sailboat. With no load it revs up to 3400 rpm which says the govrenor is working. Under a load the max rpm is 1500 rpm and smokes bad and leves a trail of black unburmed fuel...
  12. F

    88 sea ray 135 Hp Marithon No Fire

    The owner was motoring out of the marina and it shut down like turning off the ignition switch. Wont start and has no fire It cranks over fast and has no fire to the plugs. I can run a volt check with my meter. Does any one have a wiring diagram or any idea where I should start. There is 12...
  13. F

    DT-5 Suzuki ,no low end power

    Hi, I have a dt 5 Suzuki that starts after 5 to 10 full choke pulls. When you put it in gear at low rpm, it has no power and dies ( in the 55 gal.test tank).I have swaped out carb and power pack from another dt5 and this did not effect any thing. I suspect possible bad crank seals , intake leak...
Top