Search results

  1. D

    Volvo Penta Control Box Removal

    I have a 2002 Volvo Penta control box that I need to remove and can't seem to take it apart. I need to replace it before the weekend. Any help will be greatly appreciated.
  2. D

    25 HP Merc dying when shifting or under load

    I have a 1996 25 HP Merc that is dying when it is put under load or when shifting. I've check the carb and it seems to be working fine and spark is good. Any suggestions?
  3. D

    Small outboard oil mixer

    Is anyone familiar with the OMC oil mixer that apparently can be used with Mercury outboards. If so, I have one that I want to use and it doesn't have instructions. Does it just install into the fuel line? Thanks...
  4. D

    Mercury 60 HP Main jet recommendations

    Anyone know the recommended jet size for 4500 ft. elevation on a Mid 90's 60 HP 3 carb Mercury?
  5. D

    1986 OMC Cobra 4.3L point gap?

    Anyone know the point gap for a 1986 OMC 4.3L?
  6. D

    Waverunners dying - help!

    I have two Yamaha Waverunners, a Wave Blaster II 760 and a Wave Venture that are dying. The Wave Blaster runs great until you turn and then it bogs down and will sometime quit. The Wave Venture runs for a few minutes at full rpms then dies. It's hard to restart initially, then it eventually...
  7. D

    Merc 470 trim pump

    I have a trim pump on a '79 merc 470 that stopped working. All I get is a clicking sound on one of the solenoids/relays. I can't tell which one is clicking. Neither the up or down works. Any suggestions? Is there a way to test it? I'm not that good at electronics, so any help will be greatly...
  8. D

    Mercruiser inboard tach, volt mtr, and temp gauges don't work

    I have a Ski Supreme w/a Merc. v8 inboard. While dewinterizing it, I notice the tach, voltage meter and water temp gauges don't work. They have power, but don't work. Help! I have a trip to Lake Mead in a few days and don't want to miss it and there isn't a shop around that can get to it that soon.
  9. D

    DT25C Suzuki Dying at full throttle

    My 25HP Suzuki is dying at full throttle. I had the carbs rebuilt and seemed to help some, but not that much. I took the carbs out again and checked every jet and all was clean and clear. Any suggestions?
  10. D

    Volvo 275 trimming

    I have a Volvo 275 on an '89 Bayliner and it won't trim while in gear. Is it not supposed to or is there something wrong with it? It hasn't worked since I got the boat last year.
  11. D

    Bravo Trim Pump Troubleshooting

    I just installed a new trim pump for a 95 7.4L Bravo and it sounds like its working fine but it will only raise the drive an 1/8 of the way up and the trim indicator shows it being 3/4 of the way up. It stops like as if is all of the way up. Any suggestions?
  12. D

    Trimming Volvo 1989 275 5.0 Drive

    Does anyone know if there is a hydrolic lift system that can be put on an 89 Volvo 5.0 stern drive so I can trim my boat? I have an 89 Bayliner with the 5.0 and I am not getting about 36 miles an hour. Thanks.
  13. D

    Suzuki DT25C - Dies while in gear.

    My Suzuki DT25C seems to work just fine when it is in neutral, but when I put it in gear and begin to give it throttle, it likes to die unless I give it full throttle. Basically, it dies at low and midlevel rpms while in gear. Any suggestions?
  14. D

    DT25C Suzuki Shift Shaft

    I recently had to take the lower unit off of my Suzuki 25 HP and I can't seem to figure out how to put the shift shaft back in without removing the powerhead. Does anyone know any tricks?
Top