Search results

  1. S

    Loose outboard

    I have an Evinrude 6hp on the back of a 12 foot alumacraft. I had to replace the transom board due to severe rot. The only way to do that was to get a board that was thinner than the previous one. Now my outboard wont clamp on tightly, even with the clamps all the way down. I need a sure fire...
  2. S

    Evinrude Alternator

    I have a serious question. I have a 12 foot Alumicraft that I got for free from my neighbors. Being free, it sure as hack wasn't in good condition. I got to working on it, and decided to go the whole nine yards. I have an Evinrude 6hp from the 80's I believe. It doesn't have an alternator, but I...
  3. S

    Yamaha 4

    I have a yamaha 4 from the mid 80's i think with a long shaft. I need to know if it is possible to shorten this. If not, can I use it on a boat that is better suited for a 15 inch shaft? I know that this will reduce performance, but I want to make sure it won't cause harm to the motor or the...
  4. S

    Shorter Shaft on Yamaha 4

    I have a Yamaha 4 hp that I need to use on a 12 foot Alumicraft. Unfortunately, this motor was built in I'm guessing the mid-70's. It is a long shaft motor, seeing as it was on the sailmaster 22 before. I need to know if there is a way to shorten this shaft and if so then who can I contact for...
  5. S

    Mercury 3.5

    I have a Mercury 3.5hp from I believe 1984. I just bought it used off of my ol neighbor. I am having trouble with water circulation and the throttle. I cannot see any water circulation, and I am not sure if the Mercury is even water cooled. With the throttle, the propeller will run at idle...
Top