Search results

  1. H

    Yamaha 50 tlr prime start test

    Hey Guys, I have a 2008 Yamaha 50 TLR 3 cylinder 2 stroke. The prime start or fuel enrichment lever that goes into middle carb has 3 settings. On, run (or auto) and off. Starts right up in run mode just like it should, but runs rich and has no power if I leave in the auto mode. If I turn the...
  2. H

    Need a picture of 2008 Yamaha 2 stroke upper cowl

    Hey Guys, 2008 Yammy 50 tlr. Top cowling doesn’t want to go on like it used to. Pretty sure the front L like bracket on cowl has been bent. Would like to see what it should look like before I start bending it to correct fit. Here are pictures of my cowling and the bracket in question. If...
  3. H

    2008 Yamaha 50 tlr procedure to adjust oil pump injection linkage ?

    Anyone have the complete procedure for adjusting this linkage? The pump linkage connects to bottom carb and the to oil pump which attaches to block on port side.Engine has a single oil tank that mounts to port side of engine
  4. H

    Yamaha 50 tlr 2 stroke throttle stiff at engine

    Hey guys, like title says the throttle is stiff to open up. It is a “push” to increase throttle. I recently bought motor and just installed new cables. controls work freely when disconnected at engine when I hook up its somewhat stiff. Stiffness is coming from the linkage on engine. It all...
  5. H

    Attaching marine plywood to aluminum stringers/framework on 1980 sea nymph fm161

    I was surprised Thayer the floor only had 1/2 plywood. Also it was held to stringers by rivets. I am leaning toward using 3/13 sheet metal screws. Would rivets be better? Thanks
Top