Search results

  1. O

    98 150 Johnson Ficht High Idle

    After cruising around the lake and pull back on the throttle, the rpm's stay high. Will only come back to normal if the motor is turned off and then restarted. Has anyone experienced a similar problem with the early ficht.
  2. O

    Honda accelration problems on carbureted models

    Has anyone experienced acceleration issues when the throttle is opened quickly. The carbs have been completely done. Float height set and all jets clean. The motor has been run-up in test tank and the lync and sync was done with the vacuumate hooked up to the motor. The idle speed is correct and...
  3. O

    Wiring diagram for 1976 115 evinrude

    Looking for a wiring diagram for the trim & tilt system of a 1976 Evinrude 115. This pump motor has three wires coming out of it, Blue, Green and Red. There is also a small black wire that attaches to the outside of the pump body. Missing the Solenoid box inside the boat and have to make one up...
  4. O

    Boat Porpoises At Any Trim Angle

    I have a 1976 17' J Craft with a 150 Ficht motor on it. It also has a hydrlaulic transom jack with a six inch setback. The excelleration is amazing but any trim angle and the boat porpoises. However it still gets to 54 mph with the boat running flat and little bow angle. This boat is a flat...
  5. O

    Merc Verado Oil Change

    What is the quickest way to change the oil and filter on a 200hp Verado. Thanks in advance.
  6. O

    No Spark thunderbolt 3 merc650

    Are there any tests that can be done to diagnose the swichbox, or trigger in the distributer, without the ignition analyzer. Any help would be greatly appreciated. The mercury switch has also been dissconnected.
  7. O

    Motor dies when the engine cover is put on.

    I have a 1965, 9.5hp Evinrude, that when the motor cover is put on, even half way, it starts to slow down, stumble and eventualy quite. The base gasket area looks good and no apparent leaks. The big rubber seal, low in the belly-pans, also appears to be in place. It's as if it is getting...
Top