Search results

  1. R

    Trim motor test results

    1985 150hp evinrude E150STLC0S Trim motor model number 10810N The book calls for 394176 Trim motor Trim motor was only working intermittently. Both trim telays tested within range. Fully charged battery, clean connections etc. I bypassed the relays and replicated the same issue. I removed...
  2. R

    This carb gasket doesn't look right?

    1985 150hp Evinrude E150STLC0S Original mounting gasket is bottom picture. Top photo came from the Evinrude site part number 439076 See how the new gasket is exposing part of the opening? This is going to be a problem, right??
  3. R

    Tilt & Trim reservoir plug 0321284

    Is there a better option out there somewhere to get away from the slotted reservoir plug? I am also not thrilled to spend $25-$35 for a single screw! 1984 Ranger 1985 Evinrude E150STLCOS
  4. R

    Carburetor/primer fuel line size?

    E150STLC0S I searched but couldn't find the answer. About to rebuild carbs and replace all fuel lines. What size fuel lines are the smaller ones? Like the ones from the primer solenoid? TIA
  5. R

    1984 150hp Evinrude Vro conversion question

    Model info in pix (E150STLC0S) Which of the two brass niples is for the pulse limiter to the crank case? When i 1st hooked it up the primer bulb would not get hard. I noticed while priming with bulb that gas was coming out near the lower unit. I took a pix of it but the size of file was too...
  6. R

    Evinrude Tilt and Trim

    My 1984 Evinrude 150Hp tilt stopped working. It won't move either direction. Back story: Went to winterize boat. Raised the outboard, later it was stuck in full up position. Lowered by Manual Release Valve. Fluid looked very "frothy". After checking fluid level and topping it off, fully charged...
Top