Search results

  1. M

    1994 evinrude 140hp V4 cutting out.

    I purchased a 1994 evinrude 140hp v4 looper in 2023. The individual i bought it from said it cuts out intermittently and thought it was the carbs he had also removed the 2 cycle oil reservoir and was premixing. After rebuilding the carbs (appeared to be recently rebuilt) put in new thermostats...
  2. M

    1994 evinrude 140hp v4 cutting out at wot

    I have a 1994 evinrude 140hp v4 (crossover I believe.). After running at wot for a mile or so it will start cutting out and will only run smoothly at about half throttle. I've replace the power pack, plug, wires, ignition coils and rebuilt all.4 carburetors. Any suggestions?
  3. M

    Stuck in drive

    Hello all... I recently purchased a 1983 15hp evinrude for a winter project. First time on the water and it got stuck in forward. A plate under the fly wheel had oreinted its self in a position that prevent the shfter from moving. It went in to foward smoothly so im assuming that the plate...
  4. M

    Alternator not putting out 14 volts.

    Hello all I have a 1990 larson 180 lazer wit a 3.7l mercruiser. The boat had an alternator kit on it when I bought it(replaced the original stator that it came with). The voltage gauge usually show about 11 volts at idle then drops a little at cruising speed. The alternator appears to be new...
  5. M

    Best prop fuel economy

    Hello all I have a 1991 Larson 18 laser se With a mercuiser 3.7L alpha 1 Gen I and I currently have a 17x14.5 prop. At WOT I'm running about 38mph at 5300 rpm. I am not familiar with the 3.7L. But 5300rpm seems a bit high (at least compared to the 3.0L , 4.3L and 5.7L that were in our...
  6. M

    Trim issues

    Hello all I am having problems with trimming my lower unit. Goes down fine but comes up halfway slowly then needs help the rest of the way. And stays up. I have no leaks that I can see and the reservoir is full. I'm assuming it's my pump but before I splurge for a new one I'd like to be...
Top