Search results

  1. A

    Still trying to make it run, trying to make sure the timing is correct.

    I work on this until I get mad, then wait a few weeks then start again. It started and ran fine for a little while, then stopped and would only run for a few seconds. I had used a carb kit with what I would call a rubber-type bowel gasket and when I took the carb apart I noticed that it was...
  2. A

    JW-10 will start, then die.

    I took off the prop of my Jw10 to run it and make sure it would work before I a couple of hours to use it. It started fine, water was coming out and it was idling and would come up to a higher speed. adjusted too far and got a miss-like sound out of it. Then it shut down like it was not getting...
  3. A

    JW-10 starts runs for a a minute or two then shuts off, can restart but shuts off quickly

    The JW-10 has new coils, new condensers, plugs, and plug wires, Plugs are gapped, points have been cleaned and set. New carburetor kits. It was disassembled, soaked in carb cleaner in the can overnight. Ran down the carburetor passages with a wire tool and clean with air from the compressor. I...
  4. A

    JW10 no spark problem?

    The old coils we probably original, I have never seen something cracked so badly. I replaced the coils. Then measured them out, following the Outboard motor repair guide for the 53 to 67. replaced both plug wires with metal core 7mm. good continuity from the end of the wire through the coil...
Top