Search results

  1. P

    Should water be ejecting?

    I'm working on my NSF 15C 2009, NISSAN. Does anyone knows if this motor has to warm up before the water ejects out of the small tube? I don't want to replace the impeller if it isnt bad?
  2. P

    Combustion Problem?

    2009 4Stroke 15hp. NSF 15C. Nissan I have spark. I have fuel out of the fuel pump i have fuel in the bowl of the carb. With the carb off, in my hand, with fuel in the bowl simulating throttle, i can see and hear the fuel being injected into the carb throat. Yet this motor will not fire...
  3. P

    NSF 15C 2009 Still won't start

    The latest development is that I tested the spark plug spark and it jumps 8mm no problem. So now I'm back to the carburetor. I've had it apart twice and cleaned it thoroughly. I've disconnected the incoming fuel line and see fuel flowing when the motor is turned over. I've unscrewed the plug...
  4. P

    Tried everything, except what's really wrong.

    NSF 15C, 2010 MODEL, won't start. Replace magneto, pulser coil, ignition coil cleaned carburetor twice, installed new plugs tested kill switch and neutral switch. This thing won't start. I've also tested peak voltage, but that's irrelevant because I've replaced all the parts. The CDI i...
  5. P

    NSF 15C No Spark.

    Would anyone know the resistance for the Pulse Coil? Can't find the spec anywhere. I think the ignition coil is fine, I checked the safety lanyard and the neutral safety switch, all good. My current reading is about 194 ohms for the pulser coil. Thanks Nick
  6. P

    No spark on 2009 15hp ouboard

    Trying to diagnose the no spark. I can't track down the resistance reading I should have on the Pulser Coil. I think my ignition coil is good, have not tested the stator yet. What should the resistance be?
  7. P

    Leak or no leak?

    I have this 72 OMC 225hp, trying to fix a leak or perhaps it's meant to shoot water out of this location? It's doing the same thing on the port side. Before this it had black RTV or something smeared all over the seams. I took it apart, cleaned the surfaces, replaced with a new gasket, O ring...
  8. P

    Nothing to starter

    Hello, I'm taking a break from a tilt trim motor problem. This is my new problem. 1972 OMC TUFM-21C. 225 Outdrive. That's it, that's my problem, i have this boat in the first place. Just kidding. When I turn the key nothing but a buzz sound, like a speaker. I get no click, like a bad...
  9. P

    Testing 72 OMC 225 OUT OF WATER in

    Other boats I've had I've used the ear muff attachment hooked to the garden hose. This boat dies not have the water intake I'm used to. There is a cap, garden hose size on the intermediate housing. Also looks like the intake is at the bottom of the lower section of the outdrive. What's the...
  10. P

    1972 OMC 225 Tilt not working

    Hello, First time asking a question. Hope this is the right forum. I replaced a broken pin that fits in the slot on the worm gear. The trim motor works and spins the spur gear clockwise and counter clockwise. But.....when I attached the tilt quadrant gear to the out drive engaging the spur...
Top