Search results

  1. T

    Bent Lower Shift Shaft

    Did a pressure test on the lower unit. Needed a new shift shaft seal. Installed a new one and still showed a leak out of the shift shaft seal with soapy water. Pulled the shift shaft out to take a closer look and noticed it was bent at the spot where the shaft goes into the seal. I’m assuming...
  2. T

    Bayliner Blank Gauge Cluster?

    I have a 2006 Bayliner 185 Bowrider and I have some crack in the gauge cluster. I have looke all over the internet and cannot find a new, or used blank gauge cluster. Anyone have any ideas where else I can look or ideas….? The pic is what it looks like.
  3. T

    What Bearing Puller?

    Trying to replace the top cover bearing cup on the upper drive shaft after replacing the seals. The race has some pits in it. In the manual I only see the parts number for the puller rod? I can’t seem to find any pullers that will fit so I can actually pull the bearing cup out. What did you guys...
  4. T

    Soak Bearings in Rust Remover?

    Replaced the oils seals in my alpha one gen 2 upper drive shaft. Everything looks good. However, my upper driven gear assembly looks like it has some light rust on it. Nothing that worries me. But I was thinking about submerging it in some WD40 rust remover, clean it off really well and re lube...
Top