i just want to give this guy a shout out, if you need vintage outboard decals, this dude is the way to go, stock, custom, whatever. no, i do not get anything from this. fyi
Vintage Marine Decals, ebay.
A guy walks into a bar carrying a set of jumper cables, sits down and asks the bartender for a bottle of whiskey, bartender says, OKAY, but you better not try to start anything.
Any OPINIONS as to use dielectric grease on spark plug wires. on this engine, the spark plug wires are NOT soldered to the coil, they are held in place with a bakelite nut that holds the end of the wire to a flat connector on the coil. would it help, or hurt to use a dab on the end of the plug...
hypothetical question, would it be possible to test spark if i put the flywheel on without the keyway and just spun the flywheel on the crank to test spark to plugs? sounds feasible to me.
Guy walks into a bar with a set of jumper cables, goes to the bartender and ask, bartender, give me a shot of whiskey, bartender says okay, but don't start anything.
Didn't know where to post this so i figured i would start here, My name is KEN and have been running 2 stroke motors for 30 plus years. Sorry if i have offended anybody on here but i will give my opinion on any post i feel fit. If that is not allowed, do as you will. Will not comply with any...
looking to buy this motor for a winter project and was wondering if you could still get parts for this old of a motor, carb kit, impeller etc etc. don't know how deep in i'm going to have to go as far as motor. owner says motor has compression but thats all. any thoughts?
Went fishing sunday, wife got pi@@ed, she hasn't talked to me since, watching hazel, leave it to beaver and twilight zone. BEST TWO DAYS OF MY LIFE..........
I just couldn't see spending 100+ on a transom riser soooo this is what it is. Finishing work left to do. 14 foot jonboat with a suzuki dt8. Total cost, 19. Sorry, im poor.
i have a 14 foot jon boat flat bottom with a suzuki dt 8 on it. the cavitation plate is 2 inches below the bottom of the hull. would it be to my benifit to raise it so its even with the hull. boat runs a little nose high and doesn't really plane but pushes the boat pretty good. i know about the...
looking on suggestions on a new prop, the one i have is factory, planing is okay but i want one for a little more speed. motor is on a 14 foot jonboat and does pretty good now. just trying to outrun those elusive asian carp from jumping in my boat. lol. the only number on the prop i can find is...
the motor runs great, idle's good and all seems fine but at full throttle on the water, sometimes it pops, if i throttle down just a hair it doesn't do it. any thoughts? carb has been cleaned and dialed in per me. one pull start.
as you can see with my current setup, the boat ALMOST planes but not quite. yes i have moved the motor in different plane positions and found the sweet spot but not quite. question, if i put a set of hydrofoils on, will this help? be easy with me. lol. a little weight measurement. me on the back...
I have been looking for covers for my jon boat seats for a while, seems there are none out there unless you are ready to pony up 200 plus, Well there is an alternative for cheap. picked these up for 8 dollars and they fit good, non slip and 200 degrees cooler. time will tell on quality but if...
just bought a jon boat with the suzuki dt8, put it in the water for the first time today. started it up, ran good until it hit a rock at idle and it stopped. didnt hit prop and no damage done but it quit. tried starting again and i think i flooded it but i noticed it was spitting fuel out of a...
