Search results

  1. corytha

    Resistor wire

    I installed new electronic ignition and 3 ohm coil. Took the boat out for a ride yesterday. After about one hour driving it cut off with a hot coil. Do I need to move the resistor wire? If so so will be electric choke, still work?
  2. corytha

    PerTronix 1146A Ignitor for Delco 4 Cylinder Distributor

    Do I need to remove the purple wire on the positive side? I see some videos on they do some videos they dont.
  3. corytha

    Coil

    I will be changing my coil tomorrow. After motor runs for 40 min or so it cuts off like no gas. Then when cold starts right up. New carb, new fuel filter, new fuel line and water separator, new plugs and wires and points. Anyone had this happen before?
  4. corytha

    Plastic where zinc goes.

    1989 Sea Ray 16 ft. Have a mercruiser 3.0 alpha 1 outdrive. I bought a zinc kit. The place where I put the square zinc directly underneath the hydraulics for the tilt lift have a plastic piece that is connected with a wire. I cannot put the zinc there because the piece is. Can I cut it off?
Top