Search results

  1. B

    Thread locker for permanent underwater applications

    Red (permanent) locktite states is only water resistant whereas blue (non permanent) states is waterproof. Anything available that is both waterproof and only removeable with high heat that can withstand vibrations from boat/motor running? Thanks!
  2. B

    CMC pt130 actuator replacement

    So I finally bit the bullet and ordered the replacement actuator for the pt130 after modifying the mount for a much less expensive linear actuator only to have the actuator fail at the end of the first run in the water. The factory cmc actuator I ordered comes with the spring pins for mounting...
  3. B

    Transom plate sealant question

    So I finally pulled the trigger on a used CMC power tilt and trim for the Jon boat. Before taking the old motor off, I saw that the outside portion of the transom had an 1/8” thick aluminum plate attached, that the motor had mounted to. Unfortunately the size of the plate was just a little...
  4. B

    CMC PT130

    Anyone know how much the PT130 with the added clamp on adapter would raise the motor height if mounted even with the top of transom? Thanks
  5. B

    CMC PT-130 Actuator dimensions

    Anyone have a pt-130 they don’t mind sharing dimensions for the actuator assembly and distances between connection points on the jack plate in both fully open and closed positions? I can’t seem to find this info anywhere I’ve been looking. Thanks!
  6. B

    Weak tell tale after electric work

    I recently had to splice in a new 8 pin wiring harness from the remote key switch line to my 1985 mercury 35 hp el motor because I had a bad connection and it melted the old wiring. I spliced each of the 8 wires separately with heat shrink solder connectors and then bound them all together with...
  7. B

    Adding power tilt and trim to manual motor

    I recently purchased a Jon boat with a 1985 mercury 35 hp el long shaft motor with manual trim. Im wanting to change to power tilt and trim and I see that at the time the motor was originally made, mercury also offered power trim option. I have seen a used power t/t that says for mercury 1984-93...
Top