Search results

  1. H

    johnson 150 1985 storage

    I have a 1985 johnson 150 that is going to be stored for a year without being run. I have no wear to put it inside so unfortunatley. I need to know what it is there is I need to do to the motor so that way when I get back from overseas I can get it running easly.
  2. H

    1985 V6 150 Johnson burning up power pack

    I just bought a new power pack for the right side. I hooked it up and then started the motor. It sounded great and was running good as well. Then all of a sudden I watched the new pack just burn up. I am lost for words and dont know what else to do I have a manual and have been doing everything...
  3. H

    1986 150 Johnson no Power

    Saturday the boat was on the river and running WOT between 4500 and 5000 rpm. I stoped it for a minute to turn around and started to head back. I gave it full throttle and the boat would not plane out or anything. At this point WOT throttle was between 2500 and 3000. I shut it down looked at the...
  4. H

    1986 150 V6

    Hey there everybody. I have a 1986 V6 150hp Johnson. I was out fishing this past weekend and when I went to leave the motor would not start at all. At first it acted like it would turn over but after a few cranks it was dead in the water. I took the top plug out on the left bank and checked for...
  5. H

    Blowing Steam

    I have a 1986 Johnson 150 V6, I went out and put muffs on this morning and let it run for few minutes before taking out. After a few minutes of running it started to over heat and blow steam. All the plugs are good, no steam cleaning here. I did find a bunch of mud betwen the lower unit and the...
  6. H

    RE: 1986 JOHNSON V6 150

    RE: 1986 JOHNSON V6 150 Hey there guys sorry about the impatience last night I was getting agravated not at you but this stupid cable network that I have. <br />Anyways I looked at the antivent plate and it is sitting an inch and 1/4 below the keel. I went and looked at a neighbors boat and his...
  7. H

    1986 Johnson 150 V6

    The Motor lost the water pump and over heated. I replaced the water pump and took it out the next weekend and the motor ran ok and was only running at 4300 RPMs and according to Your site that is not very good and almost Lugging the engine as yall would say. I did a Comp. check and all Cylinders...
Top