Search results

  1. A

    Tohatsu MFS 40A

    Hi Had a MFS 40A year 2020 4 Stroke tohatsu installed with remote control, electric start and PTT. When the ignition is switched on the REV and trim meter illuminate thus the gauges lights are on all the time. Is there any slight modification to make them light up with the nav lights...
  2. A

    Suzuki 225

    Hi i would like to confirm the following. When mooring the boat for a period of time the owners manual states the following. tilt the motor engage the tilt lock and lower the motor down to rest on the bracket . then continue to press down the PTT switch until the trim rams are fully retracted...
  3. A

    mercury 20hp 4 stroke

    Hi all, I have a mercury 4 stroke 20hp about 3 years old and about 150 hrs. I have noticed that when the engine is starting the oil warning lamp is not turning on. I checked its connections and also the oil pressure switch connection both seem fine. Oil level is ok and type to specs etc. I am...
  4. A

    tohatsu tacho wiring

    Hi, I have a tohatsu 20 hp tiller 2014 , and bought a tohatsu tacho 3AC726400M new model with oil lamp. the tacho has 6 wires as follows blue - black for night illumination white - yellow for tacho (through factory harness) green and red. what are these for. are these applicable for the...
  5. A

    20hp accessories

    I am planning to buy a 20hp long shaft ,tiller with electric start, carburettor engine mercury o/b and would like to install a tacho. Pls advice if this is possible and what are the part nos of the rev counter and harness appx 15 feet. Thanks
  6. A

    propellor selection

    Hi need some advice on the propellor selection I tried the boat today and wto only succedded in reaching about 4200/4300 rpm,The speed was tremendous which i really do not need. The engine is a evinrude etec 90hp ( manuf specification rpm range 4500/5500)fitted with standard manufaturer prop...
  7. A

    90tldi

    Hi one for you Tohatsu Guru. Just a basic info. the tldi can show fault codes through a combination of the warning lights/rev counter appx 28 codes. can this be activated by a simple procedure or a computer is required.maybe you could outline the procedure briefly. 2 gear oil. is a good APLG5...
  8. A

    which outboard

    Hi Does any one own a tohatsu 90 TLDI or an Evinrude E TEc 90. maybe you could tell me how your doing with any of the above engines. any trouble, good or bad points etc.I am planning to buy a 90 2 stroke to my new boat a 17foot cabin thus i could make up my mind and try to get one right. with...
  9. A

    Tohatsu 90tldi

    Just a knowledge question. (no need any specifiuc details) To remove /lower the bottom cowl on 90tldi can it be done by removing the apron (one bolt) than removing the bolts from inside and lower the bottom cowl ex to put longer battery leads or the engine has to be removed.. thanks
  10. A

    Fuel conditioner

    Hi everyone, hope you will have a good new year. Just to confirm cause i dont see any problems but one never knows. Can i use Johnson 2plus4 fuel conditioner (only this is available here) in a tohatsu 90 TLDI. Maybe its use will effect the injectors fuel pipes etc in a negative manner. I never...
  11. A

    Loss of RPM

    A friend of mine has a johson 1998 70 Hp carburettor.The problem is that after about 15 to 20 min (after starting the engine from cold ) the engine revs drop down to 2500 and wont exceed this until the engine has cooled down about 2 hrs or the next day. He has got someone to check the carbs...
  12. A

    Johnson 50HP

    I have a Jonhson 50HP 2004 model electric start/ power tilt J 50PLSR and would like to ask 2 questions.<br />1 If the engine runs out of fuel or oil or both will damage occur to the vro pump (excluding engine or alarms sounding etc for this instance)<br /><br />2. If the engine is running or...
Top