Search results

  1. P

    Replacing batwing manifold questions (and other questions)

    Some complications: '91 omc cobra drive, but a 2008 4.3 Vortec engine. Cracked block, probably caused from a cracked batwing exhaust manifold. I guess I will get a remanufactured Vortec long block and transfer the water pump, starter, flywheel, alternator, etc. from the old engine...
  2. P

    oil pressure alarm?

    I have a '90 4.3 HO that is missing the oil pressure and water temp alarm. Not the sensors, but the alarm itself. I'm having problems trying to locate a replacement. Anyone have a link to find the part? thanks
  3. P

    OMC 4.3 HO re-power is underproped

    I have a 1991 Reinell 200 Bermuda hardtop. I replaced the old 4.3 HO 4-barrel with a new crate Vortec 4.3, Vortec intake and a new Holly 4-barrel. It runs fantastic, but I must be making much more horsepower. The outdrive is the 1991 Cobra 800 15 spline variety 1.68:1 ratio (model # 986032...
  4. P

    '91 4.3 to vortec 4.3 Ignition question

    I have a dead 1991 OMC 4.3 (non-balance shaft)engine. I want to replace it with a Vortec 4.3 long block. I know I will need an electric fuel pump and a 8 bolt intake manifold, but will my OMC HO electronic ignition system need to be replaced? There isn't anything wrong with it (that I...
  5. P

    OMC exhaust flappers...Part #?

    I need to replace the exhaust flappers in my 1990 OMC 4.3 HO. They melted in an overheat. First, what are they really called? Exhaust seals? Anti-backwash flaps? Second, what is the part number, if anyone has the parts book around? Third, the teardown showed a cracked head on one bank, but...
  6. P

    Removing intake manifold on 4.3

    Well, I have started tearing down the '90 OMC 4.3 that overheated on the Columbia, but I can't for the life of me get the intake manifold off. There are big gobs of black sealent in the valley between the heads holding it down. Any tricks I could try? The good news is the exhaust manifolds...
  7. P

    I know it's bad news, but how bad?

    First off, sorry for the long post. I took my '91 Reinell with 4.3 OMC HO engine out for the first time yesterday on the Columbia River. I de-winterized it before hand and ran it on the muffs for about 15 min. to check for problems of which there seemed to be none. I launched and ran for...
  8. P

    Cobra anode removal

    The anode right above the prop has the head of the bolt broken off. It is just rattling around and I can't get it off. Is it possible to melt it off with a propane torch?
  9. P

    Holly 4bl adjustment

    I just bought a '91 Reinell, OMC 4.3 HO with the Holly 4 bl carb. The first trip out showed that the choke was way out of adjustment. I had to rotate it 180 degrees to get it to open. It then idled and ran well, but it idled at about 800 and still smelled like it was running too rich. <br...
Top