Search results

  1. J

    fuel pump 1991 200hp johnson

    I have a 1991 200hp johnson looper, and it has a VGR fuel pump. My question is since I personally add oil to the gas, is this type of pump needed or can I use another type.
  2. J

    johnson 200hp power head

    I have the chance to buy a 200hp looper power head 1994, for 100 dollars. the ad says good block but has low compression, carbs are included still attached is this a good buy.
  3. J

    1991 200hp johnson speeds up by itself

    My problem is, I can shift into drive and be riding along then all of a sudden the boat speeds up even more without me excellerating. Has anyone had this problem and can shed a little light for me
  4. J

    1991 200hp Johnson keeps choking out

    I was testing my boat to see if I had a fuel flow restriction in the tank, I filled a five gallon bucket and ran the engine from there. I ran about six miles, until the engine sucked all of the gas from the bucket, and cut off. I tried it again, this time the engine started up, but when I tried...
  5. J

    Primer bulb still collapsing

    I changed all fuel lines from the fuel pick up back to the engine of my 1991 200 hp Johnson, also blew through the vent to make sure it was not clogged. I ran open throttle for about 300 yards and the buzzer started to sound. the signal for the overheat and fuel flow is the same,one continuous...
  6. J

    Shift rod 1991 200hp johnson, clymer manual no help

    I made the mistake of screwing my shift rod all the way in. can some one tell me what height the rod should be at when in neutral and where should I measure from.
  7. J

    Shift rod placement, manual is no help,1991 200hp johnson

    I purchased a manual and it takes you through how to disassemble and reassemble, but my problem is when I took off the foot to replace water pump I did not pay attention to the shift rod. The shift rod has a bend at the top, my question is do the bend go toward the front or the rear of the engine.
  8. J

    Thermostat for 1991 200hp johnson

    can anyone tell me if you should be able to push the thermostat open with your hand, like you can do with a car thermostat. I tried to push mine open after I took them out to check them and was not able to do so, is this normal?
  9. J

    temp gauge 1991 200 hp johnson

    I want to add a temp guage to my dash so to know when the buzz goes off if it is the over heat or the fuel flow restriction. My question is The s on the back of the gauge is where the wire from the enginge should connect right, can some one tell me where the wire is on the engine that I should...
  10. J

    1991 200hp johnson looper, fuel flow restriction, I think

    On this engine the over heat and fuel flow restriction signal is the same. I thought it might be an over heat, but I pulled every hose that water runs in or out off to cool the cylinder and there is water from all and she is peeing like a champ. My problem when I start her and its sitting...
  11. J

    running hot or fuel flow, which one

    I can run top speed for about a mile when a continuous buzz comes on. when I slow it down the engine cuts off and the buzz remains until I turn the key off then the buzz stops. my primer bulb has also been going soft, one time it was sucked flat. if this makes any sense can some one help. I...
  12. J

    fuel flow restriction

    I was riding along at full speed, all of a sudden the engine slowed down and the beep was saying fuel flow restriction. It cut off, but started up again, it would run top speed for about 30sec to a minute then do the same thing. I disconnected the primer from the side of the engine, leaving it...
  13. J

    fuel out of foot 1991 200 johnson

    my engine turns, but will not start. i noticed that there is fuel dripping from the foot and the foot smokes, but will not start. is the dripping a sign of flooding, and if so how do i fix it. i replaced my plugs and charged my battteries, as suggested, but it only spins and will not start. any...
  14. J

    new sparkplug

    what is the correct gap for a new spark plug on a 1991 200hp johnson. also is ngk a good sparkplug for this engine, or should i change to different type for better performance
  15. J

    hard start 1991 200hp johnson

    having trouble starting engine, cant tell if it is not getting any gas or if its not firing, when i turn the engine over, it smokes out of the end of the prop, does this mean it is firing but not getting any fuel. it worked like a champ for a month or two straight, then i let it sit a week with...
  16. J

    voltage drop 1991 200hp johnson

    when i connect my volt meter to the battery , it reads 12.2 volts. i leave them connected and turn the key and the voltage drops to 11.5 is this normal or will it cause my engine not to fire
  17. J

    1991 200hp johnson will not start

    i cleaned every ground i could find, wire brushed them and all, turned the key and she started like a champ. let her sit for two days and now she will not start. i turned the key to the on position, pulled a spark plug and cross jumped the starter solinoid, i saw no fire. can someone tell me...
  18. J

    coil pack, 1991 200hp johnson

    -------------------------------------------------------------------------------- i checked each of my 6 coils and the ohms on the primary resistance were 0.01 on each coil, according to my clymer manual, each should be reading between 0.05-0.15 my questions are is it normal for all to go bad at...
  19. J

    1991 200 johnson fuel flow restriction

    fuel does not seem to be getting to the spark plugs, i have to spray a fuel mixture to get it started. when running full throttle. i get a beep stating fuel flow restriction. if i give it a little gas in reverse or forward it cuts off, but if i go ahead and excellerate it runs. any ideas.
  20. J

    Starting fluid 1991 200hp johnson

    i wrote first thinking there was no fire, but i sprayed starter fluid in and it started right up, but when i push the choke in or lift the red lever and bypass the fuel solenoid, without using the starter fluid, the engine turns but will not start. any ideas on what is going on
Top