Search results

  1. A

    Rough Idle "82" 115hp Evenrude

    Okay guys, I'm trying to figure out why I have a rough idle on this motor. I've checked the gap on the plugs, Compresion is about 120 on each cylinder on the starboard bank and runs around 100 on the port bank. I've also rebuilt the carbs and the fuel pump. I've completed most of the test on...
  2. A

    1982, 115 Carb rebuild

    When rebuilding my carbs on this engine the manual says to remove the intermediate orfice. I cant seem to find it. Also the rebuild kit I baught only has 2 orfices in it. I would think there should be 6. Two high speed, two low speed, and 2 intermediate speed. Here is a pick of the carb I have...
  3. A

    115, 1982, Water in Lower unit

    Went to cange the lube today and have the milky white coming out of the drain plug. What is the best way to proceed. The manual talks about the prop. shaft leaking. Where else would I look for the water leak? Should I drop the lower unit and inspect? Searched 20 pages and could not find a...
  4. A

    Choke Problem 115 hp 1982 evinrude

    This motor is mounted Bayliner about the same age. The problem is when I pull up the choke (the handle on the rear inside of the control box) to start the motor the trottle on the motor does not move at all. The plastic gear inside the control box might be bad but I'm not sure. My manual does...
  5. A

    Starter/Battery 115 1984 Evenrude

    Hi All, Once and a while the starter gear on my 115 1984 Evenrude won't go up and engage the flywheel. Once it does engage the motor turns over fine. So my question is: Do I need a new starter or starter rebuild kit, or would the problem be that the battery drains enough that the starter does...
  6. A

    2 stroke vs 4 stroke

    Probably a silly question but, what is the difference between a 2 and 4 stroke motor? I have a 1984 115Hp Evinrude but not sure what kind of oil to mix with the gas.<br />Thanks,<br />Arrow
  7. A

    starter 1982 115 hp

    Hey All,<br />The starter on my outboard went out this last weekend. Just to verify I get 12 volts at the starter terminal when the key is turned. The gear turns, but it won't engage to the flywheel. Is it possible to rebuild it or should I get a new one? If a new one, how do I find a part#? <br...
  8. A

    evinrude 110 hp ID

    just need an ID for the boat motor I just bought. Can anyone help me out?<br />MOD # E115MLCNB<br />Ser.# J0155051.<br />Thanks<br />in advance!!<br />Arrow62
  9. A

    Wards Outboard I.D.

    Hi,<br />New to the forum.I would like to ask about my outboard so I can get parts for it. I think it is from the mid 80s.<br /><br />Wards<br />Model # VWB 521190<br />Serial # 38X27743.<br /><br />Thanks for your help!!!<br />Arrow62
Top