Search results

  1. B

    140 looper,idle bounce

    Not shure if this is even a problem,runs great at mid to full throttle but seams to shake while navigating the "no wake zones".Have rebuilt the carbs ,set idle timing to spec,changed plugs (champions),changed thermostats,water pump,head gaskets,compression is 130 on all 4.Don't know what else to...
  2. B

    humminbird TCR-ID 1 transducer

    hello all,I have an old humminbird that is still in good shape but can't find a transducer for it.<br />Does anyone know a good source for hard to find or discontinued parts?
  3. B

    17 ' invader ,lost in the detail,got pics,need painting advice

    Hello All,thanks for a great forum,I am trying to fair the hull for painting.I have several nicks and gouges in the chine and can't seam to find the right method to reshape them after applying my fairing compound. I have tried using a DA sander,a hand block and even a body file but after sanding...
  4. B

    hot looper

    hello all,I have some concerns with the temp I'm getting from my J140TLCDC.I just installed a water pump kit,and new thermostats.The impeller that was installed was the pin drive type and was obviously not turning due to markings on the impeller and drive shaft.I replaced it with the wedge type...
  5. B

    carb soaking

    hello all,I have read on several posts about cleaning carbs and they all suggest soaking the carbs and then blowing them out.I would like to know if it is ok to soak plastic carbs in the bucket of carb cleaner sold at auto part stores.I haven't found any that don't say not to use for plastic...
  6. B

    WOT timing

    I would like to check the WOT ignition timing on my J140TLCDC outboard and can't figure out a safe way to go WOT without assistance.Can this engine run WOT on muffs or does it need to be on the water? I know this may seam like a simple question but I am not sure what to do.Thanks in advance for...
Top