Search results

  1. T

    Mercury control compatability

    I have a 1993 25hp Mercury outboard with console controls on my current 15ft aluminum boat. I need to purchase a 10 hp or less outboard to use on some smaller reservoirs in my area. Will these 1993 controls be compatible with say a 1996 Mercury 9.9 or would they not work?
  2. T

    Fixed but nervous

    So for the past few years I have been having issues with my 95 Johnson 112. 2 yrs ago we went out in very rough seas and after getting to our destination we could not get boat started again. Got it home and realized if we just unplugged kill wire at motor it would fire up. We looked allover...
  3. T

    Main Red Plug

    Having spark issues on my 95 Johnson 112. After watching several videos on you tube I saw one that said make sure I don't have any voltage going through my kill circuit. Well when I disconnected it from power pack I was getting 12volts. So I pulled the red plugs apart at the motor and under...
  4. T

    1995 Johnson 112 SPL

    I am having trouble with my 112spl. Thought I had fuel issues so I rebuilt carbs and that still didn't fix it. I am able to get it fired when it is in the forward detent while in neutral but it quickly shuts off after a few seconds. It won't start at a high idle at all and will quickly turn off...
  5. T

    1995 Johnson 112

    Is this linkage supposed to twist like this in picture with red circle when in forward WOT? When it is in neutral it mates back up with the control cable like in 2nd photo.
  6. T

    1995 Johnson V4 Shift linkage

    I replaced my water pump and now trying to get the linkage connected properly. I slid the pin mechanism back through the linkage but is it suppose to slide through the other hole on the starboard side of the shift rod? Right now I can get it to shift but this black bracket seems to be bending...
  7. T

    1995 Johnson 112 won't stop trimming down

    I have a 112 johnson, the motor has been great so far since i owned it but on my last trip out last year the motor would not stop trimming down. I eventually removed the green and white wire from the plastic box after it was in the water as I didn't have to worry about depth. Anyway, is there...
  8. T

    2002 Merc 90hp 2 stroke won't idle after winter storage.

    So I sold my boat to a friend and of course it won't idle after telling him the boat has never had an issue for me. Anyway, the boat wasn't used much the last few years but it was used twice last year and it did idle fine my last time out. I fogged the engine and I did put seafoam in the tank...
  9. T

    '95 Johnson 112 torque specs

    does anyone know what the torque specs are for the water cooled rectifier bolts and also the flywheel nut? Thanks!
  10. T

    Checking water cooled rectifier

    I have a water cooled rectifier on my 95 Johnson 112 engine. I want to make sure that it is working properly since I am not getting a charge at the batteries and my tach is also not working. All the instructions and videos I have read has the rectifier removed from the engine and being tested...
  11. T

    1995 Johnson 112 SPL rectifier?

    Hi! I have a 95 112hp engine that isnt providing any juice back to my batteries. My first guess was to check my rectifier since my tach isnt working either. Anyway, I looked all over this engine but cant seem to find one. Did these models have rectifiers on them? I looked them up on the...
  12. T

    95 Johnson 112 Shift Rod Height

    I want to make sure my shift rod height is correct. Can someone verify that 21 1/4 inches is what I am supposed to have for a 95 Johnson 112? Thanks in advance!
  13. T

    Bent prop shaft vibrate less at high speeds?

    So I got a 03 Merc 90hp ELPTO that I replaced the swivel pin on over the winter because it was really worn out. It wasn't too bad considering i had to remove the power head, midsection and lower unit but now its all back together and I had it back on my pontoon boat and this weekend I was able...
  14. T

    Where do these wires go?

    Hi! So I had to replace my swivel pin this winter and now have it all back together and was able to get all of the wiring back together except for these 2. I am pretty sure they were not hooked up to anything when I took it apart but I am pretty sure I am not the first person to work on this...
  15. T

    Shift Rod Removal '03 90hp Classic

    I have a worn out swivel pin so i need to replace it and as I look at the motor it seems like a pretty easy fix all except for the shift rod that runs through the swivel pin. Before I rip it apart I want to make sure I am able to get that shift rod out from the bottom. I have been searching on...
  16. T

    2003 Merc 90HP Swivel Bracket Removal

    I have a 2003 90hp 2 stroke engine that has worn out splines on the swivel bracket and you can rock the engine back and forth quite a bit. I want to start ripping it apart to get the bracket out but I was wondering if there was a certain step by step process I should be following? I know I...
  17. T

    Pontoon Ventilation Problem

    Just got a used pontoon this year and have really been enjoying it but have had some issues as well. I believe my boat has a ventilation problem because at times I can drive along and it will be running fine and then with a wind change or start going over larger waves the boat will start to...
  18. T

    03 Mercury 90HP Swivel bracket play

    Just bought this boat a few weeks back but when I was hooking up my transducer to my boat the other day I noticed that the retaining clip just under the lower yoke was just laying on top of the lower unit. I am assuming it it is suppose to be in the lower yoke some how because it isn't doing...
  19. T

    Water Spray on '03 Crest 22 Sport

    I just bought a used Crest pontoon and noticed that when I am running at higher speeds that water shoots up the cracks between the adjustable transom. They are very minor slits maybe about 1/8 to 1/4 inch wide but the amount of water that comes up through there is pretty intense. I was...
  20. T

    Rectifier or Stator-'03 Mercury 90 hp Stroke

    I know this has been gone over but I think I have narrowed it down but before I go over to my boat today I wanted to get a final opinion of what could be wrong. I was out the other day and when I went to start my boat it cranked a few times then stopped. I figured I left something on and that...
Top