Search results

  1. R

    Transom Replacement in Open Boat (SeaNymph)

    Going to look at replacing the transom board on my alum open boat this w/e. Eisting board is not soft yet but looks really bad. See lots of references to 'Matting' between the laminates as well as GM Sealers. Some related questions follow: I will be using some quality (appr. 1 1/2" thick)...
  2. R

    Impeller Replacement for 88 15 hp Evinrude

    Gonna get my moneys worth from this forum yet!! Thinking I should replace the impeller on my 88 Evinrude. Bought it used and believe it sat for a couple of years. I do have a good stream out the overboard but not real strong. In a search on this forum I saw a reference to a Step by Step...
  3. R

    'Nother Dumb one: Where do you put your battery?

    The battery in this old Sea Nymph is setting on a wooden shelf attached just below the transom on the right hand side (looking forward). Is this normal? It kinda looks home made. I was wondering if it would fit under the last seat... Where do you-all put yours? Also thinking of not even...
  4. R

    Dumb Question: Where do you put your fuel tank?

    I put the brand new plastic tank between the last seat and the transom in my old Sea Nymph. Tends to slide around a bit and rest on top of my left foot all the time. Looked at placing it forward of the last seat but that does not look much better. Where do you-all put your tank? And how do...
  5. R

    Idle Speed on 88 15 hp Evinrude

    Step 5 in the Manuals Idle Speed adjustment procedure is to set the 'idle speed adjustment' to appr. 650 RPM. Is this the set screw on the Cam Follower? I didn't actually have to adjust it because I liked the idle speed the way it was, but I would like to know where this is. The parts layout...
  6. R

    Help Removing Twist Grip

    How do you remove the twist grip on a '88 15 hp Evinrude with ordinary tools? Need to lube the inside, but do not have the special tool the book calls for. Thx, Ray L.
  7. R

    Which Tach do You Use?

    What service tach do y'all use? My calibrated ear drum is getting a little waxed up and I'd like to actually verify the speed settings I have been using. Be good if I could locate a tach that would work for 1 cylinder and two cylinder engines. I have a Case Ingersoll tractor with a Briggs &...
  8. R

    Stiff Throttle Grip on 88 15 hp Evinrude

    The twist grip on my 88 Evinrude is a little sticky and stiff to twist. (Before you ask:I do have the clamp backed way off.) What is the reccomended lubricant, and do you have to dissasemble it to lube it up? Thanks. Ray L.
  9. R

    Tuning Out of the Water

    Is there a way to apply a load to these 2 strokes w/o using a barrell of water? I find that if I run in a barrell and want to run the engine at load for a while, it tends to empty the barrell all over me and the area I am working in. Muffs are good for low speed tuning, but can't throttle up...
  10. R

    Cam Follower Adjustments for 88 15hp Evinrude

    I just replaced the cam follower on my 15 hp Evinrude. I think I got lucky in that it seems to run fairly well. Good response to throttle and seems to rev up 'real' high... I do not have a small engine tach (any suggestions?) and it is not under load (running with muffs) so I can't say for sure...
Top