Search results

  1. D

    1996 150 hp volt meter reading

    Every now and then I see my volt meter move up from 14 to 16. It stays there for a minute or so and then goes back to 14. It has just started doing that. Could it be a battery problem? Thanks in advance for any info.
  2. D

    1996 150hp v6 trigger problem

    The engine has had low speed problems for a while. It started really skipping recently when trying to go wot. I checked the spark, no spark on #2 and when moving the trigger cable, no spark to #4. I figured it was broken wires from the constant movement. According to the merc service manual, the...
  3. D

    1993 140 v4 evininrude ignition?? problem

    My engine has started missing at idle and also at 2000-3000 rpm. It runs for a few seconds and then it has a miss, almost like the whole ignition shuts down for a few milliseconds. It then puffs out some smoke like it clears out the cylinders and runs a few more seconds before it does it again...
  4. D

    Gel in fuel tank, what to do?

    I bought a boat that had been sitting up about one year, according to the owner. I pumped all of the old gas/oil mix out with an electric fuel pump, put in one bottle of water remover and then 32 gallons of fresh fuel and oil mix. When I started running the boat, a slime, gel substance would...
  5. D

    1996 150XL rebuild parts question

    I already have the block bored and new wiseco forged pistons but I saw that one of the reed valves is cracked. What kind should I order and where? I have to order the seals, bearings and gaskets also but they seem to be more available.
  6. D

    Question about Mercury V6 head casting numbers

    I am trying to find a replacement head for my 150 HP head, casting # 18787-C4. I have found one with18787-C2. What does the C2 and C4 represent? Is this the same head, possibly from another mold or another date? Thanks Mike
  7. D

    Leaking stator, 1990 evinrude 200HP

    I have noticed that the stator is leaking some black substance onto the timer base area. I have also noticed the volt meter stays around 14.5 to 15.0. Is this voltage too high and could this cause the leaking or is the stator just going bad. I haven't verified that the meter is accurate on the...
  8. D

    1990 evinrude 200 stator question

    I recently replaced the timer base and noticed the coating on the stator had melted and dripped down on the mounting screws. I thought this must be from some previous , corrected electrical problem. The motor runs fine and I have about 6 hours running time since doing the work. I pulled the...
  9. D

    150 hp powerhead exchange

    I have a 1996 150xl Merc. and I am looking at a 1998 Optimax with a short shaft. Will the 98 optimax fit on my foot assembly? Thanks a lot for any info. Mike
  10. D

    Repair manual question

    I need to rebuild a 150 hp engine. Anyone have a feel for which manual would be better, Clymer or Seloc? Thanks in advance.
  11. D

    Where all is the serial number listed?

    I bought a 1996 boat and mercury 150 offshore motor. Where is the serial # on the motor? I see a place on the main mount that maybe something was removed and it has void written all over it. I hope this is not the only identification on the motor.
  12. D

    evinrude 200hp flywheel removal problem

    I have some firing problems and have checked out the previous posts. After reading the posts, I think I need to start the engine and do the spark test again. (Boat is 135 miles away). I have attemped to replace the timer plate but cannot get the flywheel off. I used the correct puller and have...
Top