Search results

  1. W

    Johnson 1982 35hp

    Is it possible to get a new female red connector , someone cut the end off when I first got the motor
  2. W

    How hard is it to change a long shaft to a short

    I have a 1992 30 evinrude long shaft that I would like swap the lower part with the 1985 25 evinrude short shaft, What does it take to do this ? I checked the part numbers on the exhaust mid section and they are the same. I have a jet unit on the 25 hp and just need more power and also the 92...
  3. W

    92 25 hp Evinrude-electric primer

    Was idling when the engine quit and wouldn't start after that. Pulled the cowling off and noticed fuel spraying from somewhere near the base of the schrader valve. How does the primer actually work? and why would fuel be spraying out without pressing on the key? Is there pressure there all the...
  4. W

    7.5 late 70's mercury

    My engine runs great at slow speed and up until about half throttle and it will not pick up any RPM above that. Anyone have this problem ? any idea's
  5. W

    Just brought a 84 mercury 7.5

    And I don't have an owners manual, so can someone tell me what the little rod that runs down the forward part of the lower unit is for, I think it's something to do with the locking of the engine for backing up. and also what is the screw at the top of the lower unit that says flush ?
  6. W

    changing to a bravo pump

    If you change over to the bravo engine driven raw water pump and still using the alpha gen II leg, what do we do with the pump in the leg ? Can you still use the alpha leg to supply water to the new bravo pump or do you have to install the thru hull pick up. Whats the best way to go on this, please.
  7. W

    change alpha one gen II to a Bravo one

    A friend gave me a bravo drive, it's a bravo one. thats in very good condition and I would like to change them out if at all possible . Mine is a 5.7 GM. any thoughts on this ?
  8. W

    Can anyone tell what this is

    A friend gave me this lower leg, said it didn't work on his boat and after looking close at it, it's not going to work on mine which is an an Alpha II, can anyone tell from the picture what it could be, I'm thinking it maybe a bravo I.
  9. W

    Alpha one gen. II shift cutout

    I have a 1992 5.7 mercruiser Alpha one gen II and how does the shift cutout work, Isn't the roller on the switch suppose to move off center when you are shifting into forward or reverse momentarily and what makes it move ? When I have someone operate the remote shifter and I watch it, the roller...
  10. W

    intake manifold

    I bought an edelbrock 2104 manifold that awhile back someone here said they used on there 350 mercruiser. It has two holes that go into the exhaust crossover. I think one is for the automotive choke and I am not sure what the other is. My Question is what do you do with them ? I am thinking of...
  11. W

    Quicksilver perfect seal

    The mercruiser manual says to use quicksilver perfect seal on the head gasket and threads of the bolts. They say for stainless head gaskets only. I dont have any perfect seal and I've never used sealant on head gaskets before. This is a 5.7 mercruiser , what would you use and place of perfect...
  12. W

    Marine engine performance book

    I am looking for a copy of small block chevy marine perfromance by Dennis Moore. I can't find one and I talked to Dennis Moore, he says they are out of print and hopes to get some more. If anyone knows of one let me please let me know. I understand its a good book and would like to read it.
Top