Search results

  1. D

    150 evinrude bored 20 over

    im in the process of rebuilding a 150 v6 60 degree eagle spitfire 1991.I had two cyl bored 20 over and the other 4 honed. I ordered 2 pistons with rings and 4 sets of rings for remaining pistons wich are ok. the new pistons came with 2 rings wich are exact in size and both tapered unlike oem...
  2. D

    omc gasket sealing compound

    Is there any other substitute for omc gasket sealing compound? Should you use lock-tite on lower end gearcase bolts?
  3. D

    92 evinrude v 6 loopcharged spitfire 60 degree

    i had to cut the driveshaft to remove power head .can i remove the drive shaft from the lower end without removing the prop shaft. heed to install new driveshaft thanks .
  4. D

    Frozen Driveshaft Spline 150 Evin

    Is There Any Other Way To Free The Driveshaet From The Power Head Befoe I Cut . Tryed Spray Heat Wedges No Luck . Thanks
  5. D

    150 Evinrude Powerhead Removal, Pls Help?!

    I am trying to remove the powerhead for rebuild. The driveshaft spline is frozen in the crank shaft. Tried lower end removal, didn't work. Any ideas on freeing frozen spline?:eek: nightmare...!, thanks.
  6. D

    runaway 150 evinrude not good

    first startup of season boot on good stream of water running about 1000 to 1500 rpm motor runs away to full thottle by itself . shut ignition still running shut batt switch still running pull all six plug wires still running for about 30 seconds. motor overheats and dies. this is a first for me...
  7. D

    92 evinrude 150 v6 60

    trying to pull powerhead for rebuild driveshaft spline frozen in crank any ideas ? tried to drop lower end no luck all bolts free pb blaster sray on spline 5 days
Top