Search results

  1. W

    bogs down at WOT

    1993 90 hp evinrude. runs fine at low speed. after 10-15 seconds boggs down. if i pull back on throttle its okay again. the boat ran perfect for about 2 outings and then started this. primer ball seems alright. i'm going with a fuel problem ( could be electric though). maybe a clogged orfice...
  2. W

    1988 88hp spl johnson WEIGHT???

    how much does this engine weigh? any idea?
  3. W

    1993 Envinrude 90hp

    Looking to rebuild my carbs. engine won't start unless I use starting fluid. wont stay running. Anyone direct me to some detailed pointers on how to rebuild these puppies. what does the rebuild kit consist of? any tricks or things to pay close attention to?
  4. W

    What year 15hp????

    Johnson 15hp. pull choke. rich lean mixture switch. kill switch on tiller. serial number on engine block 8188908. my guess is early 80's also any suggestions on how to run the rich lean switch??
  5. W

    Ignition 1988 88hp spl

    Well last night in the darkness i observed a few things. while cranking, i do have sparks from the plugs in all 4 cylinders but only when the timing base is in one particulat "sweet spot". i do have a new power pack. I did observe a big spark also :confused: underneath the fly wheel (forward...
  6. W

    1988 88hp spl

    Need a power pack for this engine and/or part # ?<br />any help appreciated.<br />-sean
  7. W

    stator, coil, rectifier, powerpack (CD Ignition)

    can someone define these: stator, coil, rectifier, powerpack (CD Ignition), timerbase. in terms of how they realate to each other and what they do. how do you know when you have a bad timer base? i have 1988 88 hp
  8. W

    power pack test- 1988 88hp johnson

    Is there an easy way to test a powerpack from this engine. i have it off the engine and just need a quick way to see if it is sound. my hunch is that i have trouble with the timing base under the fly wheel but before i go there i want to rule out a bad power pack. comments on power pack testing...
  9. W

    1988 v4 88hp spl TIMER BASE

    Has anyone replaced a timer base on this engine. I got my engine started with great difficulty. (carbs are clean) I disconnected the timing linkage and can only keep the engine running by placing the timer base (on starboard side) in one sweet spot. If I move it forward or aft it buggers out...
  10. W

    1988 johnson 88hp SPL CARB??

    We'll my outboard is extremely hard to start. when i do get it started it will only stay running when at high RPM. (high RPM obtained by opening up flaps on carb with connecting linkage rod) Do I have a broken Reed valve(s)???? or stuck float(s)??
  11. W

    carburetor hoses on 90hp evinrude 1993

    There are small diameter carburetor hoses with white lines on them.<br />they go to various pickups on the carbs, manifold, block, primer solenoid. <br />do they have a replacement kit of hoses (black with white lines) with t-connectors etc. <br />also, is there a schematic available somewhere-...
  12. W

    Parts needed 1993 90hp Evinrude v4 croosflow

    for arson damged engine:<br /><br />-a cowling<br />-electric fuel primer solenoid<br />-VRO replacement fuel pump (I am dumping the vro oil injection)<br />-splash guard (plastic cowling shroud underneath engine)<br />-tilt switch (the one mounted on the starboard outside of the engine)<br...
  13. W

    Tilt Limit switch 1993 90hp eninrude

    there is a tilt limit switch near the tilt tube. <br />it limits the upward tilt of the engine preventing damage.<br /> it is damged (melted) beyond repair. <br />there are two wires attached to it. <br />can i remove this part and simply snip the wires. <br />or should I twist the ends of the...
  14. W

    OMC Parts On-Line?

    Is there a concise OMC parts catalog on the web??<br />in particular for 1993 90hp evinrude<br /><br />cheers<br />sean
  15. W

    technical questions 93' 90hp OMC (fire damaged)

    Question #1: does a compression check tell you anything about crank shaft seals or crank case seals. my outboard has minor fire damage (thanks to arson). the heat does not seem to have been too severe. the cowling is fried. the oil injection pump melted and electric fuel primer is scorched a few...
  16. W

    fire damage to outboard

    Evinrude,90 horse, trim and tilt,electric start,long shaft, 1993.<br /><br />what is the best service manual for this. there seems to be diffrent publishers.<br /><br />the engine suffered a wee bit of fire damage in a boat fire. the cowling is scorched and a few plastic parts on top of the...
  17. W

    what outboard is this?????

    evinrude<br /><br />model# E90TLETS<br />ser# G03241887<br /><br />what year and horsepower is this motor??<br />thanks<br />sean
  18. W

    Power Tilt/Trim 1988 Johnson 88spl

    I need help changing the fluid on my tilt & trim unit. There is the fill plug in front and a manual override screw on the side. The manual overide screw on the side leaks. I want to take it out and replace the o-ring there. Has anyone done this? (it is what I am particulary interested in) There...
Top