Search results

  1. 8

    1987 Omc Cobra 5.7 Outdrive Question

    Im Getting Ready To Reinstall The Outdrive And Need To Know When Reinstalling The Out Drive What Position Should The Shift Lever On The Outdrive Be In? Neutral ? How About The Shifter Itself ? Also, Is Permetex Required On The Gasket Seperating The Outdrive From The Transom Assembely ? What...
  2. 8

    omc cobra 5.0 outdrive question.

    getting ready to reinstall my outdrive. i dont have and alignment tool handy. but i do have an input shaft yoke available. currently, i am able to slide the yoke smoothly thru the gimble bearing and into splined adaptor with little effort. i can also feel the slight resistance when the o rings...
  3. 8

    how smooth is smooth. cobra outdrive alignment

    1987 5.0 omc cobra after having the engine rebuilt im ready to re-install the out drive. i took a great deal of care making sure the motor settled back onto its old position when i put it back in. i dont have an alignment tool handy, but i do have an extra input yoke to use to check the...
  4. 8

    1987 omc cobra 5.7 thermostat

    is there an automotive equivilant to the thermostat for my engine ? Its not the same as the standard chevy thermostat for this year and im hopin to get this thing going today. boat shop is closed ) : j:mad: j
  5. 8

    1988 5.7 chev omc cobra water pump.

    need some info on changing the water pump in the outdrive. im havent been experiencing any heating probs but im doing maintenence and figure i might as well. j
  6. 8

    thermostat permanently part of thermotstat housing ? chev 5.0 cobra

    after pulling my thermostat housing i noticed it that the thermostat appears to be pressed permanently into the housing itself, with no way to remove it short of destroying it. do i have to buy the entire housing just to replace a thermostat? ) ; chev 5.0 omc cobra. j
  7. 8

    pulling the motor from my bayliner 5.7 omc cobra

    hello (plz pardon my ignorance in advance) I have an 87 bayliner with 5.7 chevy motor. Ive pulled the outdrive and have prepared the motor to be pulled. My question is, are there bolts or fasteners attached to the engine flywheel that need to be removed? (example, the bolts that hold the torque...
  8. 8

    Attention Don S! info on omc sterndrive removal

    don, do you have a link to an online manual for omc outdrive removal like the mercruiser link you have previously sent other members to ? I have an 87 bayliner 5.7 with an omc cobra sterndrive. Im replacing the motor and i am looking for some info to help make the swap go as smooth as possible...
Top