Search results

  1. dmas

    How to raise WOT RPM on a Yamaha 200 TXRR ('93)

    Hi everybody, I recently got this boat, I cleaned the carbs and adjusted the timing, it was 4 ATDC and I changed to 6 ATDC per OEM service manual, WOT RPM before adjusting the timing was 5200 now it wont go over 5000 RPM, I also adjusted the throttle opening from the remote like the manual says...
  2. dmas

    DF115 water on tilt and trim, how to drain it?

    Hi everybody, I started noticing tilt and trim fluid on the floor underneath my motor and when I removed the plug to check the level a lot of contaminated fluid came out...it was light brown in color, kinda looked like milk, I think the water is coming in thru the o'ring around the tilt rod...
  3. dmas

    '03 Johnzuki 115 water on tilt and trim reservoir

    Hi everybody, I started noticing tilt and trim fluid on the floor underneath my motor and when I removed the plug to check the level a lot of contaminated fluid came out...it was light brown in color, kinda looked like milk, I think the water is coming in thru the ring around the tilt rod.. my...
  4. dmas

    DF115 fast Idle function not working

    Hi everybody, anybody has had this problem before? to start my motor I have to advance the throttle and let it sit for a few seconds before going back to neutral, after that the motors idles fine. I know this motors have that feature, mine was not running when I first bought it, now I have it...
  5. dmas

    '03 johnzuki 115, DF owners, is this normal?

    I have an '03 that I bought and fixed but I haven't been able to get it on the water yet, engine runs fine at idle, I have only been able to test it with a hose and when I open the throttle and the motor gets to 2-3K RPM the engine starts to fail. I think that has something to do with the...
  6. dmas

    Johnson 115 EFI - Fast Idle Function not working at start up.

    the Fast Idle Function does not work on my motor, I have to open the throttle for the motor to start and after I few seconds when the engine is somewhat warmed up I can put it back in neutral and the motor idles fine. I know this motors are supposed to start up in high revs for few seconds and...
  7. dmas

    Need help with wiring on a '03 Johnson 115HP 4 stroke.

    I had this motor on a different hull, everything was running fine, no electrical problems whatsoever. I removed the engine and wiring harness from this boat and put it on a different boat. Now I don't have power at the ignition switch and nothing works, only thing it works is the tilt and trim...
  8. dmas

    Switching 2 stroke for a 4 stroke, can I use mixed fuel left on tank on 4 stroke?

    HI everbody I'm upgrading from a 1989 Force 125HP 2 stroke motor to a 2003 Johnson 115HP 4 stroke, I sitll have a lot of mixed fuel left on my tank, should I empty the tank and flush it with fresh fuel or can I run the left over mixed fuel on my 4 stroke? could that cause any damage to the fuel...
  9. dmas

    Awakening 2003 Johnson 115 HP Four Stroke, EFI engine

    Hi everybody, I just bought a 2003 Johnson 115 HP Four Stroke, EFI motor to replace the one on my Wellcraft, from what the previous owner told me, the motor has only 50 HS., he had medical problems and it was sitting in storage for almost 3 years and then he tried to started with the old fuel...
  10. dmas

    New Teleflex NFB steering system setup stiff

    I just replaced the helm and steering cable on my '89 125" Force, I really like the NFB system it keeps the boat straight. but I have noticed that the system is very stiff, I need to use both hands to turn it, is this normal? would it become more soft with time or there's something wrong with...
  11. dmas

    Non-thru hub vs thru hub on a '89 125HP Force

    my question is, would it make any difference if I use a thru-hub exhaust propeller on my non-thru hub exhaust motor?
  12. dmas

    15 or 17 pitch on a 89' 125 HP Force?

    Hi everybody, I have a '89 18' Wellcraft CC that has the original '89 125 HP Force motor, the motor came with a 13.5 x 17, I bought a new one aluminum prop, same size, but the motor stays at around 4500 RPM WOT and I read somewhere that 5k-5500 is the recommended RPM at WOT, should I change the...
  13. dmas

    fuel gauge needle goes the opposite way.

    I recently have my fuel gauge fixed by a shop, the guy tried the gauge on a bench test first and everything worked fine...got home installed the fuel gauge on the boat...s to sender, I to ignition and G to ground..also the sender is fine, but now when I turn the key on the ingnition, the needle...
  14. dmas

    '89 125hp Force tilt/trim pump oil

    I would like to know how to ad oil fluid to my tilt/trim motor, I know it has to be checked with the outboard on the full down position, but I don't know what kind of oil use or If it's better to bleed the whole system and ad new oil to it, thanks in advance for you help.
  15. dmas

    '89 force 125 wont crank, electrical problem

    hi last weekend I tried to start the boat, it cranked a couple of times but the third time it didnt,also the power went off, no gauges, not tilt, so I reset it the relays on the engine and turned off and back on the perko switch and the power came back to all the electronics and gauges, then...
  16. dmas

    smoke inside cover while running..'89, 125hp force

    hi hope anybody can answer this question..my '89 125hp force was running great..but las time I run the engine on the water I've noticed smoke coming out of the vent hole on top of the cover while the engine was running..it smell like exhaust smoke, after I got home and run the engine with the...
  17. dmas

    89 125 force choke selenoid working?

    the choke shutter on '89 125 force it's always wide open, it's supposed to be this way? how do I know if the choke solenoid is working? thanks
  18. dmas

    20" or 25" shaft?

    I have a 1989 Force 125HP and I was wondering if its a 20" o 25" shaft, any idea on how to find this out? thanks
  19. dmas

    1989 18' Sport CC combined fuel gauge/voltmeter nedeed!!

    HI I have an 1989 Wellcraft 18' Sport CC and the fuel gauge broke down and can't find this combined gauge anywhere, looks like it's no longer produced, it's a teleflex 3" gauge that has fuel gauge on the top and voltmeter on the bottom, can't find anything similar also, any idea where can I get...
  20. dmas

    '92 lower unit on a '89 125hp?

    Can I use a 1992 dual exhaust lower unit on my 1989 125hp force? , my lower unit it's a single exhaust and it has the water intake on the driveshaft centerline, the one that I want to get it's a 1992 double exhaust and it has the water intake on the gearcase but the shaft, shift link and water...
Top