Search results

  1. W

    Painting Question??

    I have a 1988 Bayliner trophy. It has the hard white floor in it. Woundering if that can be painted or no? Is it gel coated or just glass? And if so what kind of paint should I use? Thanks for all the help.
  2. W

    Electronic Distributor Question???

    hello, I Have a 1988 4.3 omc motor. Looking to get rid of the points and go electronic. But I cant seem to find one anywhere. Does anyone know where I can find one, or part number for one. Thank you
  3. W

    Points and timming

    ok put new points, rotor, plugs and wires in my 1988 OMC 4.3. Motor ran alot better, but as time went on it got worse again. Checked point gap and they closed up alot. I think I forgot to put grease on it, so after I reset the gap do I have to check the timming also?? Thanks
  4. W

    top speed

    Ok, I have a 1988 21 foot Bayliner Trophy. Its a pretty heavy boat and its loaded up pretty well with fishing gear. With a 17 pich prop Im only getting 28 MPH on the Gps @ 4900 RPM. This boat has a 4.3L OMC. Should it be faster, it was really slow untill I did a tune up, then it got...
  5. W

    prop for a 1988 bayliner trophy?

    I have a 1988 Bayliner Trophy with a OMC 4.3L V6. Right now I have 2 props for it a 17 and a 19 pich. Operating Rpm for the boat I believe is 4600-4800 rpm. The the props I have the rpm full throttle is 5100 for the 17 and 4900 for the 19. Top speed for both props is between 25-28 MPH. This...
  6. W

    Top Speed???

    I have a 1988 2110 Bayliner Trophy. What should I be getting for top speed with a 4.3L omc, and a 19pich prop. Boat doesnt seem like a speed demon, but I use it for fishing. Just woundering How close I am??
  7. W

    Motor problem! Please help

    Ok I have a 1988 21' Bayliner Trophy with a 4.3L in it. For some reason it ran good the first time I took it out. Now everytime I go out it gets slower and slower. Used to run 5000 rpm at around 31MPH with a 17 pich. Now I get maybe 4300 rpm and the boat wont plane out even with the trim...
  8. W

    1988 Bayliner trophy top?? Need one

    Anyone know where I can get a top for a 1988 Bayliner trophy, I see it has the orginal snaps there, but I just have a bemmie top on it now, would like to see what the orignal was.
  9. W

    Low Voltage Please Help

    Ok I have a 1988 bayliner trophy. Problem is I have very low voltage at idle, and when motor is wide open only at 13v on the dash meter. when I slow down voltage drops. If i turn the key on its at or below 10v Problems having: Trim tabs not moving Engine wants to cut out when trying to trim...
Top