Search results

  1. E

    76 70hp hesitates sometimes

    so I have a 1976 johnson 70hp, model# 70EL76. It has a hesitation sometimes off idle when put in gear. If you choke it a bit it will throttle right up and run strong to WOT. I have had the carbs rebuilt twice, changed all fuel lines, have installed three new coils,plugs. My question is, could...
  2. E

    interchangable parts for 18hp

    I have a 1969 18hp evinrude that needs a new or used lower housing support. New-NLA ,used-find the part. I have found a complete 1960 outboard . My question is, will this 1960 lower housing support change with the 1969. Also need a clutch dog . So I am wondering if I could use the 1960 for a...
  3. E

    1957 7.5 evinrude with no power

    Hello all. I have a 1957 7.5 hp evinrude on a 14' aluminum boat. It starts and runs well . In neutral it will rev up nicely but put it in gear it will hardly rev past idle. I have adjusted the low idle and fast idle with no change. Not bad for trolling but kind of slow other wise. Oh and this...
  4. E

    trim gauge

    Hello All I have a 1976 johnson 70hp with power trim model #70EL76D . The trim gauge does not work, the control works fine. I have done some checking and when I connect the purple power line and ground to proper posts the needle goes full down but when I ground sending line to proper...
  5. E

    12hp surging under load

    Hi there. I have a 1979 12hp Chrysler. It starts and runs great but it has an annoing surge when the motor is under load. Not sure if it is carb problem or the wrong prop pitch. Also it is more noticable at WOT Eric
Top