Search results

  1. C

    drunk driver

    on haloween a drunk driver crashed through my fence, hitting my boat and trailer, he got caught on the hitch which swung my boat and his truck around 180 degrees which caused his truck to hit my kids basketball hoop, throwing that into my wifes new car. the force of swinging around drove my boat...
  2. C

    flush kit

    is it possible to add a fhush kit to a 2002 ez loader tandam trailer
  3. C

    throttles controls

    can anyone explain how to change the throttle controls at the helm for a 76 twin 260 mercs. are there any srings or other equip. that will jump out at me if i disconnect the old
  4. C

    draining engines

    i have twin 1976 165 mercs and legs. they each have 3 drain plugs. i use the boat all year round so is there an easier way to drain them then pulling all six. 3 of them are tough to reach so any ideas would be appr.
  5. C

    what prop

    i have a 76 fiberform 24' cuddy twin 165 mercs and legs. weight appr. 4200 lbs. what prop would be best for overall use
  6. C

    rubber boots

    does anybody know were i can find the rubber boots that cradle wires about to go through the hull
  7. C

    battery switch

    today i was adding a panel for downriggers,gps,etc. i have a dual bat switch. the batteries go to post 2 and common, the starter cables come of # 1, and 2 more 16 g wires of additional smaller post go to what i think is a fuel pump. anyone seen a simular mess or is this jimmied. id post a...
  8. C

    new thermostat

    im going to install new thermostats to 165 hp straight 6 chevys. other than new gasgets should i do any thing else
  9. C

    tempature

    i finnally got my new boat on the water, a 1976 24' fiberform cuddy, twin 165 mercs, pre alpha legs, whaterver that means. ran like a dream, turn key, pured regardless of rpm. the temp didn't go beyond 110 is this ok.1.5 hours run time. also to change throttle controls is there anything to watch...
  10. C

    impeller

    is it hard to change a impeller on a 165 hp mercruser and leg. im not a mechanic but i do have common sense. or should i hire out
  11. C

    new panel

    i just bought a 76 fiberform 24, cuddy twin 165 mercs and the fuse panel is full. can i wire a new panel from the switch for gps, downriggers, blackbox. i have not been able to find a negative or positive buss bar, any ideas where to look. there are 17 16g wires and 7 12g wires going from the...
  12. C

    winter use

    i live in victoria bc. i just bought my first inboard so i have to ask. i use my boat all year round. 76 24' fiberform cuddy, twin 165 hp mercs. the boat will be in use most every weekend so what should i do for it occasionally get below freezing here. would a block heater work or a heater in...
  13. C

    rebuild

    im looking at a 1976 24' searay cuddy for a project boat. the cost to buy is 2000 with a crappy trailer. it has a 454 and a t2 leg. can anyone offer any advice and tell me the weight of this boat and tell me if its even worth pursuing
  14. C

    searay

    can anyone give me a opinion on a 1976 24' searay cuddy. its powered by a 454. are they goood boats and are they worth rebuilding
  15. C

    deep v

    i currantly own a 96 four winns 205 sundowner but want a boat from the 70,s or 80,s can anyone tell me what boats were good for deep v and built well. would a 1976 24' fiberform cuddy fall into this group.
  16. C

    staight six

    can anyone tell me if a 250 165 hp straight six is a good motor. it is 30 years old with 400 hrs
  17. C

    24 sea ray cuddy

    im looking at buying a 1976 24' searay cuddy. can anyone tell me if its a good boat. after the motor has run for a few minutes it smell burnt, any ides what that might be
  18. C

    24' fiberform cuddy

    i am looking at buying a 1976 24' fiberform cuddy with twin 250 straight 6 chev motors. 165 hp each. can anyone tell me the weight of this boat and if there are any problems i should look for
Top