Search results

  1. D

    Help with yamaha 40 2 stroke!

    Hello all, Just purchased a used yamaha 40 hp approx 1994 (see vid) - http://www.youtube.com/watch?v=Y6nMHPeu1GI, Ran sweet as a nut yesterday for around half an hour then started to run rough and misfire, the engine was pumping water ok and the spark seams good. Fitted new spark plugs but...
  2. D

    help with 35hp looper cuts out under load

    Hi all, Have a 1996 3cyl 35hp. Carbs and timing set up recently by a local workshop, cylinders all firing blue on the spark test, starts from cold with only a couple of revoulutions of the flywheel and ticks over perfectly. But kick it into gear and as soon as load comes on engine stops? Service...
  3. D

    1996 looper problems

    Have a 1996 BJ35QLEDC 3 cyl runs fine on cyl 1 and 2 as soon as you connect cyl 3 and run it its rough checked compression and its good around 100 psi on all cyl. If i take and HT lead off cyl 3 it runs fine again bring it close to the plug and there is a good spark jumping across so what gives...
  4. D

    1996 johnson problems

    Hello all have a 1996 Johnson 35hp 3 Cyl , Run it in a tank and it changes the water white in colour. also it seems to idle ok but if you advance the fast idle and bring it back it cuts out also if you fast idle it after about 4 mins it will cut out its pumping water fine. Also not getting any...
  5. D

    johnson 35 ecu problem 1996

    Hello have a 3 cyl 35hp, mod no bj35qledc , The powerpack is situated on the port side looking from aft on this are 2 holders for electrical connections. one of these is connected (the larger one) the other isn't and there doesn't appear to be anything to connect it too. there is a red wire and...
  6. D

    Johnson 35 mod. BJ35QLEDC 1996 problems

    Good day all, Hoping to solve some problems with my engine as i'm new to outboards. First thing Its very smoky! I ran the engine first time out with some oil also in the fuel tank which the manual said you could do. Since then its been very smoky. 2 Stroke oil seems to drip down the casing...
Top