Search results

  1. P

    1995 95 johnson T&T motor?

    Can you tell me where exactly the tilt & trim motor is located? It quit suddenly. The relays click. Is there a fuse after the relays?
  2. P

    T&T fluid 90 hpJohnson?

    I cant figure out where to put the T&t fluid in my 1995 90 h.p Johnson ML? When I try to raise or lower it the relays click and it doesnt move. It was working and just quit? Any ideas?
  3. P

    Engine wont crank Mercruiser

    Some one left the radio on for a few days and the battery went dead. I charged it and now only get a slight clicking. Changed batteries,same thing. All the connections are tight and clean,circuit breaker checked. Power tilt and all accessories work. Its a 1997 3.0lx with less than 60 hrs.Any ideas?
  4. P

    Radio reception

    Do they make a special antenna for boat radios? My reception sucks and its a new boat!
  5. P

    Temp guage wonky

    My needle wiggles and jiggles. At WOT it goes past 240,reduce speed slightly and it rapidly drops to 190. At 35mph or 4600rpms it reads 190. In no wake it reads about 180 after about five minutes. When I give it the gas it imediately goes to approx. 230 then comes down to about 190. Confused...
  6. P

    merc 3.0 135 hp i/o 1997

    Merc 3.0 temp guage reads all the way hot most of the time.Needle flickers back and forth,between 160 and past 240.Water is spraying out the back. Where is the temp sending unit located? Any tricks?
  7. P

    How could impeller be turning wrong way?

    Someone said maybe new impellor might be turning the wrong way. If I bent the tips counter clockwise and the key is in,doesnt it have to spin only one way. Im not getting any water to the thermostat. It bubbles like crazy in the garbage can. Is $50.30 crazy for just a thermostat? !966 Evinrude...
  8. P

    Impeller spins clockwise?

    On a 1966 Evinrude If the impellor spins clockwise the ends should be bent towards counterclockwise right? I only noticed the shift shaft and drive shaft sticking up from the lower unit. Is there one sticking out of the top to transport the water? I still have no water to thermostat. You guys...
  9. P

    No water going through thermostat housing.

    I just bought a boat with a 1966 80 hp Evinrude. The seller Said it might need a new water pump so I changed that but it was still too hot to touch. I then was going to change the thermostat and decided to start it to see if there was any water flow. With the thermostat housing open and the...
  10. P

    Light wire fire

    I just bought an old boat that had a burned out light bulb. When I put a new one in it lit up then the wired behind it really started smoking. They werent bare or grounded. Any ideas. It was a front light. 12volt. Pontoon
  11. P

    Can I run without recoil?

    I have an old Johnson 35. The rope pull got jammed and I took it off. Just the cradel on top. Can I still just use the electric start and use it that way with no harm?
  12. P

    older 35 johnson rewind jammed

    I cant get the rope untangled and there is alot of tension on it. Do I take that whole top bracket of and let it uncoil. Any ideas?
  13. P

    Where should water come out of motor

    On a 70s 80 HP Evinrude where is the water intake and outlet? Im not sure if my water pump is working.
  14. P

    Where does it **** from?

    I just got a 70s Evinrude 80 H.P. and changed the water pump with no problem,but Im not sure where the water intake and exhaust is to know if its working?
  15. P

    Johnson 35 h.p.

    What years did Johnson make a 35 h.p.?
  16. P

    Evinrude or Johnson what year?

    mod. #806630 serial #80299 2 Can an average guy change the water pump?
  17. P

    Johnson motor

    What year is mod.# 806630? Johnson o/b The cover says 60hp. Seller says changing water pump only takes about an hour,do you agree?
Top