Search results

  1. 7

    Strap problem

    I tried installing a strap on my winch recently and had a problem. The bolt to hold the strap in place was 1/4", and as the strap tightened up...the bolt broke. Do I need to use a stronger bolt? Or can I just wrap the strap around the drum a few times to get it to hold? It seems like a...
  2. 7

    Clicking after engine shut off

    I was running my 165hp I6 on the hose last night. After shutting the engine off, I heard 2-3 clicks. The clicks were 10-20 seconds after the engine was shut off. It sounds like a built-up charge was discharing, is this possible? And why would it happen multiple times? The sound is also...
  3. 7

    When to Rehub prop?

    I pulled my prop this year on my 165 hp Mercruiser, pic attached. I don't know much about hubs on these. How does this one look? I just want to make sure this is good to go for another season. Thanks!
  4. 7

    New riser installation

    I am getting ready to install a new riser on my 165hp I6. The surface that joins to the exhaust manifold is currently covered with paint. Do I need to sand that down to bare metal before installing??? Thanks!
  5. 7

    Busted riser

    I got a little, 6 oz, water in the engine oil in my 165 I6, so I pulled the manifold and riser. Found a small hole in the riser, but manifold looks good. I also noticed the flapper is gone; is that worth replacing, or should I not worry about it? Seems like I should be able to operate fine...
  6. 7

    Water leak while on hose

    I was running the engine, 250 I6, with the hose on the outdrive, 1 drive, and the water was exiting the exhaust relief ports and prop as usual, but there was also some water coming around the lower shift shaft. I don't recall this ever happening before. Has the lower shift shaft seal gone...
  7. 7

    Gear-end yoke

    I was pressing out the old u-joints from the gear-end yoke for my Mercruiser 1 drive, and managed to slightly bend one of the 'ears' on the yoke. It is only slightly bent, so I think I could straighten in back out. But, would this greatly affect the strength of the cast part?? I will probably...
  8. 7

    U-Joint and Bellows Job

    So...I pulled the drive to check aligment, and found water in the bellows and a bad water hose. Should have guessed it wouldn't be easy :rolleyes: I plan to replace the u-joints, bellows, gimbal bearing, water hose, and shift cable. Is there anything else I should replace or inspect while I...
Top