Search results

  1. M

    Do I need a Grounding Plate???????

    Hi everybody, I'm renovating my 1990 Intrepid 30'. Basically I'm just replacing everything and I've notived that there is a bronze ground plate located in the bilge area. when I bought the boat 9 years ago the plate was'nt connected to any thing and I'm wondering if I can, safely, do without a...
  2. M

    Choosing Hose Clamps?

    Hi all, I'm purchasing hose clamps for my fuel and bilge system (316 stainless steel). I know that I'm supose to get them with the ability to open at least 1/4" larger than the the internal diameter of the hoses, but what about the minimun diameter? Should I choose clamps with a minimun...
  3. M

    Redo Console

    My new engines won't require the cluster of guages that the old ones had and the redone console will pretty much look like the one pictured. Any suggestion on how to get from A to B would be helpful. Does it only require a piece of "plexi-glass", adhesive and screws or should I apply some...
  4. M

    Securing thru-hull fittings???

    I'm renovating my 30' Intrepid, however I'm not reinstalling the saltwater washdown system, and the baitwell system. This leaves a total of three holes below the waterline that I won't be needing. I will be purchasing new bronze thru-hull fittings to replace the old ones. Can I just cap the...
  5. M

    Largest Center Console Boat???

    Hello again, everybody! I was just wondering what's the largest size that Center Console boats are made. I've done some searching and have'nt found any over 37'. Does anyone know of a manufacturer that makes them any larger or is this even possible/practical?
  6. M

    Twin outboard steering, single or dual??

    I'm repowering my 30' Intrepid cuddy with twin Yamaha F250s (standard/counter). It'll probably have a top speed somewhere between 50-60mph and will be used mostly for off shore running in maybe 6ft seas. Is there any advantage in using twin steering cylinders over a single cylinder?
  7. M

    Reusing Wires/Cables???

    I'm preforming an overhaul of my electrical system, everything is being changed, but lately I've be wondering about the wires (2GA battery cables and 12-16GA duplex wires). They visually appear to be in good condition, but they could be 19 years old, probably 10. They are marine grade cables...
  8. M

    Dissimilar Metals

    Is it a "no no" to connect a brass barb to a stainless steel fuel filterhead?
  9. M

    Upsizing Trim Tabs

    I need to replace my trim tab system, the old system was a Bennett Standard Trim Tab Kit 12x12, I have enough room to upgrade to the 18x12. My question is: Would I have to drill a new hole in the transom for the pipe nipple that runs to the tabs actuator?
  10. M

    Hello iboats Boating Forums

    Hi everybody, i just joined a day ago, but have been visiting for several months. I live in the Bahamas and I'm in the process of renovating my 1990 Intrepid cuddy 30'. I'll be repowering it with twin Yamaha F250 and nearly all of the systems and hardware on the boat will be replaced. Besides...
Top