Search results

  1. C

    83 - 35hp Rude Fuel delivery

    Just rebuilt fuel pump.Getting fuel to pump - have fuel filter installed right before pump so I can monitor fuel flow - I pump bulb,fuel filter fill's up and bulb is hard. Engine will run until fuel is gone in in filter unless I keep hitting the bulb.All I did was go to a Moeller 12 gal tank...
  2. C

    83 35hp Rude Fuel starvation

    Before I upgraded from 6 gal to 12 gal tank engine ran like a champ.Out on lake the week before.Brand new Moeller 12 gal. new fuel line. Now engine will not stay running.Starving for fuel.I rebuilt fuel pump. I have a filter installed just before the fuel pump and it used to stay at least 1/2...
  3. C

    Prop

    Can some one tell me what the difference between a 10 x 13 , 10 x 15 and a 10 x 17 prop is. I have a 35 rude with a 10 x 15 and it skipped my 13' Whaler across the water great. The prop is no more :-( What performance differences can I expect from the other two prop's. ? Thanks in advance....
  4. C

    83 - 35hp rude lower unit trouble

    Got some weed's wrapped around prop and lower unit.Cleared it.Water stopped streaming out top circulation hole and soon after that the motor felt like it was moving side to side and finally popped out of gear.Made it back in at low throttle but...........what happened...?
  5. C

    83 - 35hp rude slipping

    Just replaced the clutch dog and put it back together the right way. Held toghether great for appr. 3 hr's of run time .Put back in the water today and it started slowly backing itself out of gear . When you first put it gear it lock's right up like it's supposed to.Will stay in at low throttle...
  6. C

    1983 - 35hp Evinrude / gearcase

    Update : Got that gearcase fixed. It wasn't put together right to begin with and had no lube in gearcase at all.Shifter yoke was in backward's. Clutch dog was damaged and in backward's.Here are a couple of picture's of the dog and the "thing" that was used as a cotter pin to hold the shift lever...
  7. C

    83 rude / clutch dog

    Does the clutch dog go in as pictured in the breakdown diagram or does the dog need to be turned on the shaft to cover the detent ***. with the larger side of the dog ?
  8. C

    evinrude 35 lower unit

    How do I push out the bearing and seal out of the prop shaft housing ?
  9. C

    "83" 35hp Evinrude/long shaft

    Good morning fellow boater's.First post here. O.K This engine was bought on a Boston Whaler from a Yacht club and was supposed to have had it's routine mait.Engine problem's; start's right up smoke's like a banchee,didn't smoke that much when I bought it.Leave's gas and oil slick (not good...
Top