Search results

  1. W

    evinrude 175 tilt and trim rebuild

    Hi there, I just rebuilt my tilt and trim for my 1997 Evinrude 175.. Looking back through the manual I realize my mistake... I didn't add fluid to the cylinders before closing up the end caps!!! doh!! My question is... Can I just open up the end caps and add fluid?? Or can I keep adding...
  2. W

    Wiring harness/Throttle connection swap?

    Hi All, Quick question.... Will my wiring harness and throttle cables from my existing 1980 Johnson 140 work if I swap to a 1999 Evinrude 150 (motor does not come with wiring harness/cables)?? I have combed the threads on this subject already and cannot seem to find mildly close topic?? thanx.
  3. W

    Johnson 200 OceanPro

    Hi All, I'm looking at buying a 1995 Johnson 200 OP with "unknown" hours on it.... I went to see/hear the motor the otherday. I checked the compression (before the motor really had a chance to get warm) 98-95-96-94-92-89. The motor was running on the muffs, so I understand that the exhaust...
  4. W

    johnson 140 short to long shaft

    Hi All, I think i've found a solution to my dead cylinder (wasted piston) in my 1980 Johnson 140 25in shaft..... I am about to purchase a 1980 Johnson 140 20in shaft motor for replacement. Can anyone confirm that it is possible to change out the mid-sections and make this work??? Thanks:(
  5. W

    johnson 140 exhaust

    Hi there.... Hoping I could get some info on the exhaust ports of my johnson 140 1980?? It's been sitting in the garage for close to two years now. Of the two holes just below the power head, only the one on the starboard side puts out any pressure that I can feel with my hand. Nothing seems to...
Top