Search results

  1. N

    02 200 Yamaha HPDI voltage output ??

    I've had my 02 200 Yamaha HPDI motor( 223 hrs)for about 3 years and since then I've always though the voltage output to all my electronics was a little high 17.2v ish,never higher. I always run 2 batteries and keep the switch on "BOTH".Nothing has ever fried or blown a fuse but is this higher...
  2. N

    lowrance elite 7 hdi nav cards

    Hello everyone I have a Lowrance elite 7 hdi unit and am trying to find other card options besides navionics if there are any for this unit.I currently have the navionics gold micro sd and never really liked it. The details on anything other than bay/ocean are terrible.
  3. N

    02 Yamaha 200 Water pressure issue

    Just changed out my impeller,housing,gaskets,orings etc. on a 02 200hp hpdi because it didn't seem to be pushing much water through the p-hole. At idle for long periods I would get the warning buzzer. Motor felt hot when it beeped steady. Its an average steady stream but not strong unless I go...
  4. N

    Wiring diagram yamaha gauges

    just bought a used boat with a Yamaha 200 hpdi and it has the Yamaha gauges for gas,oil,rpm,volt etc. The fuel gauge part stopped working and would like to know if there is a diagram for wiring the sending unit to gauge. Right now there is 2 wires coming off sending unit. I haven't traces them...
  5. N

    2002 yamaha hpdi 200hp info please

    hello, I'm most likely going to be buying a boat this afternoon with a 02' Yamaha 200 hpdi motor on it, 140hours. Anything I should look out for? whats the normal compression to check for? Always been a Johnson/Evinrude guy.New to Yamaha. Any info you can tell me would be greatly...
  6. N

    03' mercury 200hp saltwater series question

    is the 03 merc 200 saltwater series Direct or EFI ? 'Im a johnson/evinrude guy. know nothing about mercs..This motor is on a boat im looking to buy. could you tell me a little about them. They say it has just over 350hrs. no meter. can it be plugged in?
  7. N

    Mercury efi and johnson pre 2004 outboard feedback

    Hello, I sold my boat to get a CC and I'm searching for a new boat 00-06' range . I'm running into alot of 00-04 Mercury and Johnson motors. I dont know much about Mercury since I've always been a Johnson/Evinrude guy. Any feedback on them would be nice. Same goes for the non-ficht 03-04'...
  8. N

    Johnson 200 fuel/oil consumption

    Does anybody know what the normal fuel consumption should be, i went close to 2 miles today and used 17.2 gallons @ 4000rpms. Its a heavy 26ft seaswirl striper w/a with a 98' johnson 200 ocean pro.I always though it was under powered. Fuel has just been killing me. I used 50gal of gas to 1.5...
  9. N

    Greenhead flies!

    so im sitting here thinking about fishing this summer but then the thought of the infamous nj greenhead flies crosses my mind...there is absolutely nothing that keeps these things away.. what have you tried? whats your trick?
  10. N

    What is this?

    someone gave it to me and i have no idea what its used for, he said it was a shark knife but i cant seem to find another anywhere. pole is about 6ft and blade is 19", looks like a spear, extremely sharp<a href="http://s150.photobucket.com/albums/s109/n1ne1/?action=view&current=iphone009.jpg"...
  11. N

    Johnson 200 Lower Unit adjustment question

    Should a prop slightly spin when a motor is in neutral or be at a dead stop at idle? A friend of mine replaced his lower and the prop spins slowly.Theres no power behind it,You can stop it by hand. His motor doesnt bang into gear, My prop does not spin at idle in neutral but it bangs into...
  12. N

    98' johnson 200 starting issues

    ((98' johnson 200 ocean runner)) Just got back from my boat that is currently in the water (57deg water temp). Tried tried tried and tried to start the motor and it wouldnt turn over, So i took out one plug to check for spark, Tried to turn it over to see spark and it fired up. Put the plug back...
  13. N

    Navionics chart question

    ok i have a newer navionics card for my lowrancewhich allows me to download the charts onto any computer. if i download this to a laptop and add a gps antenna to it also, can i use it like my gps .
  14. N

    Bad new primer bulb?

    took my boat out of the water today due to irene coming and on my way to ramp my new moeller primer bulb kept getting sucked in flat but still allowed gas to flow but not full throttle.wide open warning horn would sound for check engine, started checking all lines for restrictions and all are...
  15. N

    johnson 200 tc-w3 oil evinrude vs pennzoil??

    i have a 98 johnson 200 and was wondering what if any difference it would make if i use pennzoil tc-w3 or the synthetic type.. i have used evinrude since i owned it...can i use synthetic? just wondering if theres any advantages of using any of the pennzoil oils over evinrude
  16. N

    johnson 200 to 225 conversion?

    has anybody every attempted to make their 200hp a 225, other than carbs, what would need to be changed over to make it a 225?? if its just carbs i may attempt it
  17. N

    Problems caused by ,motor being propped wrong?

    was out on someones boat yesterday and noticed there ocean runner 200hp would only max out at 4200rpms,what are some problems that could result in being propped wrong besides lower rpms?
  18. N

    94' johnson 9.9 only stays running if turn choke on/off

    just picked up a 94' johnson 9.9 and came home and started it, it fires right up easily but to keep it running i need to turn choke on/off.looks like the carb was replaced in 97(the sticker on carb has a date from 11-25-97)-chokes on, it runs good for about 15 seconds starts to die down then...
  19. N

    98 johnson 200hp lower unit replacements?

    just got in off my boat for the day and my lower unit is making a knocking noise only in gear and when i spin the prop by hand. anybody know which lower unit years/models will fit my 98' johnson 200hp 25" shaft. will ficht years fit also? i didnt take it off yet, boats in the water and would...
  20. N

    98' johnson 200 fuel problem?

    recently i've been noticing my 98 johnson 200hp has been acting strange sometimes.whenever i start it after squeezing bulb and filling carbs with gas, it fires right up but then shortly later the motor shuts off unless i squeeze bulb a second time until motors warm . also if i do a quick rev it...
Top