Search results

  1. N

    07 VMAX 150 Operating temps?

    I've got a new to me 07 Vmax 150 (carb'd). It runs and starts fine. I am looking it over and was curious about the operating temps on these. I idled and ran the motor for proababy 30 min and then idled back to the dock. I took the cover off with the motor running and put my hand on every...
  2. N

    The Johnson Curse continues...

    \\\
  3. N

    Reputable Repair Shops near Nashville, TN

    Do any of you guys know of a good Johnson repair shop near Nashville, TN? Specifically, one who is familiar with carb jetting. I already took it to one shop and was charged even though the problem was never fully fixed, so I would like to avoid that again. I am pretty certain it can't be...
  4. N

    Upper drive shaft seal

    Motor is a 94 Johnson J200stlerk. I was draining the lower unit to replace for the winter, and it came out milky....again. It was fixed about two years ago, because the plate below the water pump was worn out and the upper drive shaft seals were chewed up from the play. The seals were...
  5. N

    Carb Jet part numbers

    I borrowed and OMC manual, but have since returned it and can't get it back for a little while. I am in need of some air bleed orifices. Can someone help me with a couple part numbers? Current ones are: int #42 need .003 smaller so I think orifice #39. idle #35 need .002...
  6. N

    Still Bogging.....even after taking it to mechanic

    ===
  7. N

    200 Johnson bogging down/stalling at idle

    ===
  8. N

    Increasing carb jets

    ---
  9. N

    Inspecting Bearings

    I am working on rebuilding a 1994 200 Johnson looper. I am trying to fix it the right way since this is the second time in two years it has been rebuilt. I am nearing the point of putting the case back together, but I wanted a second opinion about my bearings. Both of the center main bearing...
  10. N

    Honing

    I am working on a rebuild of a 200 Johnson. It is about time to re-ring and put it back together. I think I should knock the glaze off the walls before I put the pistions and new rings back in. I dont know much about honing, so if you guys could help it wouls be nice. What I need to know is...
  11. N

    Damaged Crankcase cover

    ---
  12. N

    Broken Piston Ring

    I have a 94 Johnson Venom 200. The motor was rebuilt a little more than a year ago. It ran great until the other day. I made it to my spot and it cut out while idling and when I started it back up it began knocking and running very rough, so I cut it off and trolled back. When I got home I...
  13. N

    Yet another lower unit question...

    I have a 94 Johnson Venom and I noticed that it has leaked some lube on the driveway out of one of the lower water drain holes. The next thing I did was check the lower unit oil...its milky green. So I drained it and pressure tested it. It wouldn't hold any pressure at all. I bought the boat...
Top