Search results

  1. A

    1997 240br need some help

    I just bought my first Crownline!:D Got a great deal,on a 97 240br with only 260Hrs.:cool: Now i have a huge problem,theres no info on this boat! If you try to buy anything for it,its just not listed! I need to buy a new cover,and i cant find one made for my boat,i even looked on this site,and...
  2. A

    Please Help Resin Aplication Methods!!!

    I have gone through almost 5 gallons on 2 stringers!!!!! This is crazy! I know it cant take this much resin to apply csm to 2 stringers 11"x171"! Please,does anyone know any tricks or methods that work well. The resin I am using is vinyl ester and its pretty thick,I am trying to slowly poor the...
  3. A

    Question on fiberglass layers!!!

    I am using chop strand mat for first layer,6oz. cloth for second,and roven woving for last. This will go over my stringers,my question is can i lay all three layers on then poor the resin and start working it? Do you have to do one at a time and wait for it to set up before starting next layer...
  4. A

    Help! Help! Help! Deformed hull on trailer!

    I am ready to start glassing in my stringers but when i put them in for checking measurements one side is way off! I have since found out that the trailer the boat is sitting on is not the trailer the boat came with when it was purchased!Some of the bunks are only touching the hull on one end...
  5. A

    Gas Tank Bedding And Repair

    I have a 50 gallon under deck fuel tank that was bedded in the flotation foam. I am replacing the deck and stringers and need a new bed for the fuel tank,any ideas? Next question,the tank is made of aluminum and was covered in white corosion,i took a wire brush to it and have found many fairly...
  6. A

    How To Make "peanut Butter"

    Can anyone help me with what is used to make the peanut butter to bond the stringers to the hull before glassing? I am using Vinyl Ester Resin for my project. Thanks, Andy
  7. A

    Spray on glass???

    Any thoughts on just having the stringers sprayed with fiberglass? Would it be strong enough? Anyone ever tried it? Thanks.
  8. A

    Help! Marine Plywood For Stringers!!!

    I Am Trying To Find Marine Plywood Long Enough To Replace My Stringers That Run The Length Of The Boat And Cant Find Any Plywood 15' Long! Do I Have To Splice The Eight Footers? Please Help!!!
  9. A

    Ideas On The Cost Of Rebuilding Floor???

    I have just looked under the bow of my 21' Donzi bowrider through the ski storage port,and "HOLY CRAP!" The plywood under the fiberglass floor of the bow is sagging about 3 inches and the laminates are seperated. Under the rear seats the floor was so bad I could push through it with my hand! At...
  10. A

    Need Help On Winterizing Asap!!!

    I do know the correct way to drain the block,my problem is I just bought a 1988 Donzi Ragazza bowrider with 350 V8,and I cannot get to the block drain plugs! Is there another method to winterize that is just as good as removing the block plugs? I will try and post a pic to give you an idea of...
Top